fischertechnik ® robo tx interface connections. robo tx interface
Post on 28-Dec-2015
258 Views
Preview:
TRANSCRIPT
fischertechnik®
Robo TX Interface Connections
Robo TX Interface
The Robo TX Interface Connects the Computer
with the fischertechnik ®
model
The 9V power supply connects here.
The USB cable connects here.
DisplayLeft and right selection buttons control display menu.
EXT 1 and EXT 2 are connections for expansions.
Robo TX Interface
Output devices connect atM1 – M4.
Motor OutputsMotor
Lamp
Electromagnet
Buzzer
Solenoid Valve
Lamp Outputs
Lamp
Electromagnet
The other wire connects to a ground socket.
Lamp Output devices connect at01 – 08 with one wire.
[ [┴
Digital Inputs connect at
I1-I8.
Universal InputsPushbutton Switch(pressure sensor)
Phototransistor(light sensor)
Reed Switch(magnetic sensor)
Universal Inputs
Thermistor(temperature sensor)
Photocell(light sensor)
Analog Input Devices also connect to I1-I8.
Counting Inputs
Connect fast counting and digital inputs
A Few Tips
Building models is fun when they work. This is why you should follow a few basic rules.– Work carefully.– Check the movement of all parts.– Use the interface test.
Before you start to write a program for a model, use the interface test from ROBO Pro to test all parts that are connected to the ROBO TX Controller.
Interface Settings
Interface Test
Troubleshooting
• Interface Test
• Cables and Wiring
• Loose Connection– Loose plugs– Poor contact between wire and plug
• Short Circuits
• Programming Errors
top related