dsl 305e adsl modem. characteristic of dsl305e dsl305e adsl modem ppp half-bridge (default) ...

DSL 305E ADSL Modem

Characteristic of DSL305E

DSL305E ADSL Modem

PPP Half-Bridge (Default) Transparent Bridge

Characteristic of DSL305E

Conexant Chipsets (CX82310) Web interface managementSmartURL commands for DSL305E Firmware upgradeableEthernet Interface

DSL305E physical appearance

Eth/Act – Ethernet connection status. ‘On’ – Ethernet connection good ‘Off’ – Ethernet connection bad

‘Blinking’ – DSL Activity

DSL – DSL connection status ‘On’ – Connected to ATM ‘Blinking’- Training with ATM

Power – Power status ‘On’ – Power good ‘Off’ – No power, power off

DSL305E physical appearance

Line – DSL live line connect here (RJ11)

Reset – Hard reset button

Ethernet – Ethernet cable connect here (RJ45)

DC IN - Power connect here (12 Vdc)

DSL305E Screen Shots

Generic Firmware:Current V20.2.2

DSL305E Screen Shots

Connection Status•PPP connection status to ISP•Information on packets status

ADSL / WAN Status•ADSL Line connection status•WAN IP address•Subnet Address•Mac Address•PVC values•Protocol and Encapsulation Mode

DSL305E Screen Shots

Firmware upgrade•Firmware version•Upload firmware

SmartURL commands (DSL305E)

startmodem / login – To go to the ‘Quick Start’ page.Logout – To log out of ISPppp – To go to ‘Connection Status’ page.syslog – To go to ‘System Log’ page.connectrouter – To set the modem to transparent bridge mode. Once

in this mode, you will not able to log in to the modem. Hard reset the modem to set it back to default factory mode.

IP address of Modem : 10.0.0.2

Multi-user Mode for DSL305E

Use ‘connectrouter’ SmartURL command to set modem to transparent bridge mode.Theoretically, we can connect DSL305E (in transparent bridge mode) to a broadband router.

Note: User need to hard rest the modem to get back to single user mode

Pros and Cons of DSL305ECONS

Slow to connect to ISP. Take about 50sec to 60sec to get connected. The cause is due to the half-bridge mode of this modem. The modem will take some time to transfer the WAN IP address to the PC.

Need external power source.Pros

No driver is needed. Ethernet interface.

Q&A for DSL305EQ: Can’t used SmartURL command.A: SmartURL uses DNS methodology. Check if there are

two network cards. Check the DNS server. See below figure.

Must be *.Hasbani.com to work

Q&A for DSL305EQ: Cannot Surf the Internet even connected to ISP.A: Check proxy is turn off. Make sure proxy is off.

Q: Ethernet light is on but I can’t log in to the modemA: Check if the NIC is assign to Obtain an IP automatically.

Q: Ethernet light is not on even cable is plug in.A: Check the type of cable used. Should be straight if

connect to PC. Check driver of the NIC is properly installed.

Thank You…