647_orig
DESCRIPTION
petrachemicalTRANSCRIPT
-
Test MethodValueUnitResin Properties
D123818g/10'Melt Index
D15050.952g/ccDensity
Test MethodValueUnitThermal Properties
D1525122CVicat Softening Point
Test MethodValueUnitMolded Properties
D7901350MpaFlectural Modulus
D256/A25J/mNotched Izod Impact @ 23 C
HD-52518 HDPE for Injection MoldingProductDescription52518 is a HDPE copolymer for injection molding for application requiring a good balance between easy of processability and flowability and mechanical properties.
TypicalApplicationHousewares, high fluidity
On compression molded according to ASTM D1928C
ProcessingConditionsRecommended barrel tempratures rang between 190 C and 280 C
JAM PETROCHEMICAL COMPANYP.O. Box : 75391415, Special Pars Economic Enegy Zone, Assalouyeh, Islamic Republic of IranTel: 0098 772 7323221Fax: 0098 772 7323311Customer Technical SupportTel: 0098 772 7323074Tel: 0098 21 88626490Fax: 0098 772 7323311Website: www.jpcomplex.com
Rev.0
10
100
1000
1 10 100 1000 10000
Viscosity
(Pa.s)
ShearRate(1/s)
Shear Viscosity@190C
-
StorageandHandlingPolyethylene products (in pelletized or powder form) should not be stored in direct sunshine and/or heat radiation. The Storage area should be dry and preferably don't exceed 50 C. JPC would not responsible about quality diminishing such as color change, bad smell or est. which caused by bad storage conditions. It is better to process PE resin within 6 months after delivery.
The technical information suggested uses and application presented are belived to be accurated and reliable, however JPC makes no warranties either express or implied concerning the information herein or the use of our materials.
Rev.0