5863110
TRANSCRIPT
-
8/13/2019 5863110
1/2
www.amphenol- jaybeam.comDT
5387-EdC-page
1/2
-
Wereservetherightstomodifyourproductswithoutpriornotice-Severalpatentspendingregardingthisproduct.
880-960 / 1710-2170 MHz
58631105863010 5863010G
Model number options: 5863110 Manual Electrical tilt Antenna5863010 Remote Electrical Tilt Antenna (AISG1.1)5863010G Remote Electrical Tilt Antenna (3GPP/AISG2.0)
Access Ports Description (Connectors)
The Antenna has 2 connectors located at its bottom face and marked with colour rings. See photo next page.
Low band: 880-960 MHz ports REDrings 2 x 7-16 DIN female
Long NeckHigh band: 1710-2170 MHz ports (wide band) BLUErings
Electrical Specifications Low Band (Red) High Band (Blue)
Frequency Band (MHz) 880960 17101880 19002170
Gain (dBi) tilt 0
tilt 5
tilt 10
15.8...16.3
15.8...16.3
15.7...16.2
17.0...17.3
16.917.1
16.917.0
17.317.8
17.117.6
17.017.4
Input Impedance 50 ohms 50 ohms
VSWR 30 dB
Isolation between bands 45 dB typ. 45 dB typ.Upper Sidelobe Rejection(20 sector above main beam)
18 dB typ. 18 dB typ.
Front to back ratio >30 dB >30 dB
Maximum Power (per port) 200 W 160 W
Intermodulation3rd order for 2 x 20 W carriers
-
8/13/2019 5863110
2/2
www.amphenol- jaybeam.comDT
5387-EdC-page
2/2
-
Wereservetherightstomodifyourproductswithoutpriornotice-Severalpatentspendingregardingthisproduct.
880-960 / 1710-2170 MHz
58631105863010 5863010G
Mechanical
Dimensions (see drawing) Height: 1910 mm Width: 253 mm Depth: 147 mm
Weight 16 kg (excluding mounting accessory)
Shroud Outdoor plastic, grey RAL7035
Wind Speed Operational: 160 km/h Survival: 200 km/h
Wind load at 160 km/h Frontal: 413 N Lateral: 347 N Rear: 649 N
Mounting Kit Options (These installation accessories must be ordered separately)
Description Part number Weight
Brackets for pole 48 to 115 mm 0900181/00 3.4 kg
Brackets for pole 70 to 150 mm 0900182/00 3.9 kg
Kit to add mechanical tilt (0 to 10) to above brackets 0900188/00 1.5 kg
Wall mounting brackets with azimuth pan 0900183/00 1.6 kg
Wall mounting brackets with mechanical tilt and azimuth pan 0900885/00 3.3 kg
Packaging
Carton box
2.13 x 0.35 x 0.24 m
0.180 m3 23kg
Do not install the antenna with the connectorsfacing upward.
Installation
Antenna bottom
Tilt indicator covered by a transparent cap.Manual adjustment is accessed by removingthe cap. Knob colour is same as connectors.
For RET control, the cap must be in place.
Location of the MDCUfor RET control
Dimensions (in mm)