YP-RP8RInstallation Instructions

Rev.12/04/2018

Southern Audio Services, Inc. 14763 Florida Blvd., Baton Rouge, La 70819225-272-7135 or 800-843-8823 www.yak-power.com www.southernaudioservices.com

The YP-RP8 system does not require the YP-KP8 (keypad) to operate. You can use the buttons on the relay pack or use our Bluetooth app.

When deciding where to place the YP-KP8 make sure there is a enough cleareance be-hind keypad to be able to fish the 3.5mm power jack through the hole. Use a 5/16” or larger drill bit to make the pass through hole for the 3.5mm power jack. Feed Keypad wire through hole then center and level keypad. Use provided screws to mount keypad. Run the 6 ft. keypad cable to the YP-RP8 and plug it into the 3.5 mm femalepower pigtail.

Tip:

#1 Before screwing keypad down predrill your mounting holes.

#2 Put a small amount of silicone on the back of the keypad around the power wire right before screwing keypad down. Keypad comes with a gasket but adding silicone will make sure that uneven surfaces will seal.

Power button: Turns on/off power to the switching system. When activated keypad and relay pack icons are backlight with a white light. Caution: the system has a stand by amerage draw of 20 milliamps so system can be turned on remotely with BT and RF signals.

NAV 1st press will activate pigtails N (Navagation) and A (Anchor), button will turn green. 2nd press will turn off only the Navagation pigtail leaving the Anchor pigtail on, button will turn red. 3rd press will turn Anchor off

B When pressed, button will activate pigtail B (Bow) and turn red.

M When pressed, button will activate pigtail M (Midship) and turn red.

S When pressed, button will activate pigtail S (Stern) and turn red

1 When pressed, button will activate pigtail 1 and turn red.

2 When pressed, button will activate pigtail 2 and turn red.

3 When pressed, button will activate pigtail 3 and turn red.

Keypad Operations:

YP-RP8

YP-KP8 with 6 Ft. Cable

General Warnings & Notations:1. All Yak-Power plug and play accessories are specifically designed to work together while maintaining the correct battery polarity throughout the entire Yak-Power system. Use of other aftermarket connectors or splicing other connectors into the Yak-Power system may cause damage to the system or to the accessories connected to the system and void your warranty. 2. CAUTION: Always pay attention to the actual wire colors of all Yak-Power accessory cables to insure that the RED (+) wire is always connecting to the RED (+) wire on the connector into which it is being plugged.

Power button: Turns on/off power to the switching system. When activated keypad and relay pack icons are backlight with a white light. Caution: the system has a stand by amerage draw of 3 milliamps so system can be turned on remotely with BT and RF signals.

NAV When pressed, button will activate pigtails N (Navagation) and A (Anchor), buttons will turn red.

When pressed, button will activate pigtail A (Anchor) and turn red. Can’t be turned off when the Nav button is on

B When pressed, button will activate pigtail B (Bow) and turn red.

M When pressed, button will activate pigtail M (Midship) and turn red.

S When pressed, button will activate pigtail S (Stern) and turn red

1 When pressed, button will activate pigtail 1 and turn red.

2 When pressed, button will activate pigtail 2 and turn red.

3 When pressed, button will activate pigtail 3 and turn red.

Relay Pack Operations:

Rev.12/04/2018

Southern Audio Services, Inc. 14763 Florida Blvd., Baton Rouge, La 70819225-272-7135 or 800-843-8823 www.yak-power.com www.southernaudioservices.com

Batt

ery

YP-BTP12 (12” Long)YP-BTP96 (96” Long)

OR

YP-

BB

K

YP-

RP8YP-BBK

YP-SAE4Accessory Connector

YP-PMC48S

Power Port (Midship)

YP-LEDK-G220

YP-LEDK-RG210

YP-LEDK-BLB2

YP-LEDK-BLB2

YP-SAEY

For detailed instructions please refer to installation instructions included with each product

M

YP-PMC96S

YP-SAE4

Power Port (Stern)

M

YP-PMC96S

YP-LED SPOT

Power Port

(BOW)

360Anchor Light

Example installation

YP-BBK

M

YP-PMC48S YP-SAE4Accessory Connector

Power Port (Midship)

M

YP-LEDK-G220

YP-LEDK-RG210

YP-LEDK-BLB2

YP-LEDK-BLB2

YP-SAEY

For detailed instructions please refer to installation instructions included with each product

S

M

YP-PMC96S

YP-SAE4

Power Port (Stern)

M

YP-PMC96SYP-LED SPOT

Power Port

(BOW)

360Anchor Light

Example installation

YP-KP8

YP-RP8

N A B M S 1 2 3

Make sure to check your local laws and ordinancesfor navation light requirements.