yamaha r1 s u p p l e m e n t a r y m a n u a l · 2015. 8. 4. · yamaha r1 2007-2008 remove the...

3
Yamaha R1 2007-2008 Remove the main seat. Remove the black fuel tank covers. Remove the fuel tank. www.healtech-electronics.com S U P P L E M E N T A R Y M A N U A L for QSE-1 + QSH-P4A PAGE 1/3 Remove the airbox. Remove the voltage regulator with the plastic holder.

Upload: others

Post on 24-Jan-2021

2 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: Yamaha R1 S U P P L E M E N T A R Y M A N U A L · 2015. 8. 4. · Yamaha R1 2007-2008 Remove the main seat. Remove the black fuel tank covers. Remove the fuel tank. S U P P L E M

Yamaha R12007-2008

Remove the main seat.Remove the black fuel tank covers.

Remove the fuel tank.

www.healtech-electronics.com

S U P P L E M E N T A R Y M A N U A Lfor QSE-1 + QSH-P4A

PAGE 1/3

Remove the airbox.

Remove the voltage regulator with the plastic holder.

Page 2: Yamaha R1 S U P P L E M E N T A R Y M A N U A L · 2015. 8. 4. · Yamaha R1 2007-2008 Remove the main seat. Remove the black fuel tank covers. Remove the fuel tank. S U P P L E M

Yamaha R12007-2008

www.healtech-electronics.com PAGE 2/3

Plug QSH connectors in-line with the ignition coil

connectors.(black, 2-pole connectors below airbox)

Connect QSH black wire terminal to chassis ground.

Mount the QSE sensor.(Use the new bolt and washers supplied with

the unit. Make sure to place one washer above the sensor and one washer below the sensor.

tighten the screw by 3-4 Nm.

When tightened, do not try to rotate the sensor body.)

Page 3: Yamaha R1 S U P P L E M E N T A R Y M A N U A L · 2015. 8. 4. · Yamaha R1 2007-2008 Remove the main seat. Remove the black fuel tank covers. Remove the fuel tank. S U P P L E M

Yamaha R12007-2008

www.healtech-electronics.com PAGE 3/3

Typical position for theQuickShifter Easy.