xu100
TRANSCRIPT
Product Name Part Number
Technical Specification Summary
Frequency Range 470 – 862MHz Typ. Gain 52 dBMax VSWR 3:1 (Self Protected) Temperature Range -5 to + 45 °CDVB-T/H 100 Wrms Working Class ABSupply Voltage 100-230 Vac / 50-60Hz
48VDC (Alternative Option)
Devices: BLF878 or equivalent
Key Features and functions
General Description
Actual XU100 Picture
GR05001XU100Registered ISO 9001:2000 File No. A10480
UHF Broadcasting band (470 – 862MHz) full coverage.High PA gain allow the use of the most popular modulators with 0dBm RF Output.Provides optimal use of power devices at corresponding flange temperature.Full protection against infinite VSWR, overdrive and over-temperatureExtremely strong mechanical structureRS422, RS485, Parallel In/Out connectionsSNMP and TCP/IP Remote control
The wide range of RF Output Power provided by XU Series amplifiers makes it possible to achieve the best MER results and to hit the most demanding customer targets by finding the right power level for the specific application. In particular the XU30 has been designed in order to be put in parallel with other Amplifiers of the same kind, to build-up high power DVB-T Transmitters.
Release Date 26/04/2012Revision: 00File: XU100 Page 1 of 5
Product Name Part Number
GR05001XU100Registered ISO 9001:2000 File No. A10480
Electrical Specifications
Parameter Min. Typ. Max Units NotesFrequency 470 862 MHz Full coverage without tuning
Power 100 120 WrmsPower Input -2 dBm
Gain 52 dBPower Consumption 3,1 A @ 230VaC
V Supply 100 230 Vac @ 50-60HzInput return loss -20 dB
Gain Variation +/-0,5[1] dBF2 Second Harmonic -40 dBc
Baseplate Temp. 75 °CDigital Power (DVB-T) 50 Wrms
M.E.R. (DVB-T) 30 33 35 dB Without precorrectionShoulders (DVB-T) -33 -36 -38 dBc @ ± 4.2 MHz/100 Wrms without precorrection
Physical DimensionsWeight
ABSOLUTE Maximum Ratings
Parameter Value Units NotesOutput Power 120 Wrms
Input Power -1 dBmOperating Voltage 220 Vac
VSWR 3:1 Self ProtectedOperating Temp. -5 +45 °C
Storage Temp. -20 +80 °CBase Plate temp. 75 °C Heatsink Temperature
Electrical Interfaces
RF output 7/16 DIN female on Rear PanelRF Monitor SMA connector on Rear PanelRS485/ RS422 Dsub 9 Pin on rear panelTCP/IP and SNMP RJ45 on rear PanelParallel Input/Output Two-Dsub 9 Pin rear panel
15 kg / 33,07 lb
[1] WARM UP: To achieve the stability vs temperature correct value when the equipment is cold, please wait 30 minutes at least after switching on.
482,6mm x 132,5mm x 500mm / 19"x5,217"x19,685 "
Release Date 26/04/2012Revision: 00File: XU100 Page 2 of 5
Product Name Part Number
GR05001XU100Registered ISO 9001:2000 File No. A10480
Mechanical specifications
REAR PANEL CONNECTIONS:
Graphs and Charts
Plot 1: Amplitude vs Frequency (red line S21) & Input Retun Loss (blue line S11)
RF Out
RF Monitor
RS485
Ethernet
Internal Power Suplly
Parallel I/O
RS485 Master
Modulator Monitor SMA
FWD Power In SMA
Reflected Power In SMA
RF OUT (N), RF Monitor (SMA), Parallel OUT (D-Sub 9), Parallel IN (D-Sub 9), RS485 (D-Sub 9), RS485 Master (D-Sub 9), Modulator Monitor (SMA), FWD Power (SMA), Reflected Power (SMA), Mains Switch, Mains IN.
Release Date 26/04/2012Revision: 00File: XU100 Page 3 of 5
Product Name Part Number
GR05001XU100Registered ISO 9001:2000 File No. A10480
Plot 2: RF Monitor (red line S21) vs frequency
Integration and important Operating instructions
The XU100 is designed for operation up to 120Wrms (DVB signal) with very high linearity; this design uses 6th generation family LDMOS devices that are capable of very high peak power as long as the average power does not exceed specified ratings.
The power devices are protected by an internal circuit, for Overdrive and high Mismatch load. However is mandatory to handle with care the Input level during the "precorrection operations" due to possible very fast and high spikes coming from the source.
The XU100 has an internal Power Supply.
DVB-T Typ. Performances @ 100Watt rms Output (without precorrection) Freq (MHz) Shoulder (dBc) - 4,2 MHz Shoulder (dBc) + 4,2 MHz
474 -38,00 -37,00 560 -38,00 -37,30 660 -37,10 -37,10 760 -36,40 -36,00 858 -34,00 -33,00
Release Date 26/04/2012Revision: 00File: XU100 Page 4 of 5
Product Name Part Number
GR05001XU100Registered ISO 9001:2000 File No. A10480
Ordering informations
Product Name Manufacturer's Part n. Feature Description
XU100 GR05001 Standard version
IMPORTANT NOTICE
RES-INGENIUM RESERVE THE RIGHT TO MAKE CHANGES TO THE PRODUCT(S) ORINFORMATION CONTAINED HEREIN WITHOUT NOTICE. RES-INGENIUM ASSUMES NORESPONSIBILITY FOR ANY ERRORS WHICH MAY APPEAR IN THIS DOCUMENT.WARRANTY INFORMATION APPLICABLE TO THE PRODUCT IDENTIFIED HEREIN IS AVAILABLEUPON REQUEST. NOTHING CONTAINED HEREIN SHALL CONSTITUTE A WARRANTY,REPRESENTATION OR GUARANTEE OF ANY KIND. RES-INGENIUM EXPRESSLY DISCLAIMSALL OTHER WARRANTIES, EXPRESS AND/OR IMPLIED INCLUDING BUT NOT LIMITED TOWARRANTIES OF MERCHANTABILITY, AND OF FITNESS FOR A PARTICULAR PURPOSE, USEOR APPLICATION.NO PART OF THIS DOCUMENT MAY BE COPIED OR REPRODUCED IN ANY MEANS WITHOUTTHE PRIOR WRITTEN CONSENT OF RES-INGENIUM.
WARNING
THE SPECIFICATIONS CONTAINED HEREIN ARE SUBJECT TO CHANGE WITHOUT NOTICE. RES-INGENIUM S.r.l. ASSUMES NO LIABILTY FOR THE USE OF THIS INFORMATION. THIS DATASHEET AND CONTENTS ARE THE PROPERTY OF RES-INGENIUM S.r.l..RES-INGENIUM PRODUCTS ARE NOT INTENDED FOR USE IN LIFE SUPPORT APPLIANCES,DEVICES OR SYSTEMS. USE OF A RES-INGENIUM PRODUCT IN ANY SUCH APPLICATIONWITHOUT WRITTEN CONSENT IS PROHIBITED.
When the XU100 in installed in a 19 Inch std Rack is reccomended to leave a right space on the rear zone to facilitate the exhausted air extraction. It's suggested to leave one free unit (1 HE) at the top of the XU
The XU100 is equipped with an RF Monitor Output available by a SMA connector where is possible to test the performances when the it's on duty. The RF Monitor Output is normally > -40 dB referred to the main output in order to have a right signal managed by std Instrumentation. The logic control unit, designed specifically for this product line, accepts all necessary interfaces in every environment (TCP/IP, SNMP and RS485) for maximum flexibility. The XU100 is equipped with an RS485 on the front panel to manage and control an external DVB-T Modulator.
The XU100 is delivered in cartoon box packaging. Use all professional caution during unpacking, handling and mounting.
Please ask to RES-INGENIUM factory for any integration questions.
Release Date 26/04/2012Revision: 00File: XU100 Page 5 of 5