xprog errata sheet 001
TRANSCRIPT
![Page 1: Xprog Errata Sheet 001](https://reader035.vdocuments.site/reader035/viewer/2022081715/54650f0ab4af9fda3f8b4988/html5/thumbnails/1.jpg)
INTRODUCTIONXPROG-m Errata Sheet 001
This errata provides information applicable to the following products:● 1-002-0017 programming adapter Rev.B or earlier
These changes allow you to work with secured ARM MCU via JTAG interface
STEP1
Remove this resistor
STEP2
● Prepare the four wires. About 5cm in length.
1A
2A
3A
4A
1B
2B
3B
4B
1A
3A
2A 4A
STEP3
● Solder wire shown in the corresponding points at the bottom side
2B
3B
4B1B
STEP4
● Solder wire shown in the corresponding points at the top side
www.tmt.lt © 2009 TMT