A Z T E C H T E C H N O L O G I E S P T E L T D

Aztech WL556E

Portable High-Speed Wireless-N Repeater

WL556E Unable to connect to Wireless AP with Auto Channel

Configuration

There are a few make and models of Wireless Routers and Wireless Access Points that are having

connectivity problems with the WL556E. The WL556E Wireless-N repeater needs to be on the same

channel as the main Wireless Router/AP for it to be able to communicate properly. If the main Wireless

Router/AP switches from one channel to another, then there would be a discrepancy on the wireless

link between the repeater and the AP. To get around this issue, you have to change the Wireless

Router/AP channel from “Auto” to any specific channel for 1 to 13.

Steps to change your main Wireless Router/AP channel

1. Verify the IP address of your main Wireless Router/AP by going to the command prompt. To

open the command prompt, Click Start > Run > Type cmd and click OK

2. On the command prompt, type ipconfig and press Enter

F r e q u e n t l y A s k e d Q u e s t i o n v 1 . 0 Page 2 of 3

A Z T E C H T E C H N O L O G I E S P T E L T D

3. From the picture above, check the IP address of your Default Gateway. This is the IP address of

your main Wireless Router/AP.

4. You have to access the web GUI of your main Wireless Router/AP to be able to change the

channel. To do this, open your web browser and type the IP address of your main Wireless

Router/AP, in this case is 192.168.1.254 on the address bar

5. Input username as admin and password as admin, and click on the OK button, or check the

documentation of your router/AP for the login information

6. In the web GUI of your main Wireless Router/AP, look for the Wireless Configuration page.

Please refer to below screenshot of a Wireless configuration page for a 2Wire Wireless Modem.

F r e q u e n t l y A s k e d Q u e s t i o n v 1 . 0 Page 3 of 3

A Z T E C H T E C H N O L O G I E S P T E L T D

7. Change the Wireless Channel from Auto to any channel from 1-13. Make sure you Save and

Apply the new configuration to your main Wireless Router/AP.

8. After the configuration is completed, Please re-do the setup for your WL556E Wireless-N

Repeater.