wireless automatic water level controller with level indicator

5
WIRELESS AUTOMATIC WATER LEVEL CONTROLLER WITH LEVEL INDICATOR Join Hands With Our Technology Join hands with our technology Join hands with our technology ®

Upload: others

Post on 02-Jan-2022

22 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: WIRELESS AUTOMATIC WATER LEVEL CONTROLLER WITH LEVEL INDICATOR

WIRELESS AUTOMATIC WATER LEVELCONTROLLER WITH LEVEL INDICATOR

Join Hands With Our Technology

Join hands with our technology

Join hands with our technology

®

Page 2: WIRELESS AUTOMATIC WATER LEVEL CONTROLLER WITH LEVEL INDICATOR

Ktronics introduced the most advanced wireless technology using high frequency radio waves, which can transmit data up to 6000 meter. Most efficient codes and reliable instrumentation makes our controllers ultimate in this field.

Our wireless controllers has concentrated power density and powerfulanti-interference. We have used direct sequence spread spectrum technology can also bring further communication distance.

It can work in low power and inbuilt power save mode, which can be applied in ultra-low power consumption applications.

We are providing customer requirement based customised wireless controllers, which can offer cost effective and suits exact data transmission betweentransmitter and receiver.

Normally, our model ranges from 1000 to 6000 meter data transmission.

DETAILS ABOUT WIRELESS COMMUNICATION

Specialities:Adopt standard wireless protocol

Maximum 6000 meter transmission distanceHigh receiving sensitivity, even at low signal strength

Low power consumptionInternally installed watchdog

Working frequency: 433 / 470 / 868 / 915 MHz

Join Hands With Our Technology

®

Page 3: WIRELESS AUTOMATIC WATER LEVEL CONTROLLER WITH LEVEL INDICATOR

• Level IndicationIndicates four level on overhead tank (such as 25%, 50%, 75% & 100%) and two level in sump (such as 50% and 100%) instantaneously. These levels can be customized based on the customer need by adjusting sensor positions.

• Dry-Run ProtectionInbuilt dry run protection to avoid pump damages. Dry-run protection shall be enabled, if water is not flowing to overhead tank for specific time period, due to any reason, our controller will switch OFF the pump and buzzer will be activated with LED indication. Water flowing to the overhead tank is indicated by the set of running LEDs.

• Voltage ProtectionInbuilt voltage sensing technology provides surge protection, whenever voltage level changes to high or low, immediately pump will be switched OFF and kept it OFF condition until voltage becomes normal level.

• FILL OptionFill option is provided to switch on pump, if the overhead tank level is below 100%. This option is useful for car, bike washes and watering gardens.

• By-Pass SwitchesBye-pass switch are provided to disable timer; to run controller in regular operation and disable controller; to run pump manually, during defective of controller.

• Auto/Manual OperationAuto Mode: Pump will be switched ON, whenever tank level become below predefined(or 50%) and switched OFF in two conditions based on levels. One is, whenever tank level reaches 100% and Second is whenever sump level becomes below 25% that is below foot valve level. This facility is providing additional safety to the pump by avoiding pump dry running. Auto mode is indicated by green LED.Manual mode: Pump will be switched ON, if tank level is below 100%, manual mode does not consider sump level and pump dry run conditions. Pump will be switched OFF when reaching tank level 100% and auto mode will be enabled automatically.Manual mode is indicated by red LED.

• Pump ControlNormal Mode: Pump shall be switched on while overhead tank water reaches predefined level (that is normally 50%) and pump will be switched OFF, when level reaches to full(ie 100%). Adequate water on overhead tank is always ensured. Timer Mode: Pump ON times can be programmed using timer, number of programs will vary from 1 to 16. Above mentioned kind of pump operation shall be carried out during the time matches with timer programs. Pump shall be kept OFF if time not matches with timer program.

Input voltage : 220VAC / 440VAC 50HzRelay current rating : 30APower consumption : 12WWireless frequency : 433 / 868 MHzMaximum transmission distance : 6000 mWireless peak current : ~130 mAMounting type : Wall mountableDimension : 173 x 168 x 53 mmS

pec

ific

atio

n

GENERAL FEATURESJoin Hands With Our Technology

®

Page 4: WIRELESS AUTOMATIC WATER LEVEL CONTROLLER WITH LEVEL INDICATOR

WIRELESS automatic water level controllerwith level indicator

Special Features

Features

• Wireless communication• Instantaneous level indication• Fully automatic pump control• Dry-Run protection• Inbuilt voltage sensing• Water flow indication

• Timer based operation• Timer by-pass option• Feather touch switches• Auto / Manual operation• FILL option• By-pass rocker switches

1

2

3

4

5

6

7

8

9

1011

12

1.Wireless Antenna 2.Timer By-Pass Switch 3.LCD Display 4.Program Switches 5.ON / OFF Switch 6.Operation Status Indications 7.By-Pass Switch

8.Water Flow Indications 9.Tank Level Indications 10.Pump Status Indication11.FILL Switch 12. Sump Level Indications

Join Hands With Our Technology

®

Page 5: WIRELESS AUTOMATIC WATER LEVEL CONTROLLER WITH LEVEL INDICATOR

Connect with us on Social Media Platforms.

Join Hands With Our Technology

100%QUALITY

Address:Ktronics Automation & ControllersNo. 114, Anna Nagar, 2nd Street,Thandalam, Thiruporur,Chennai-603110

Website: www.ktronics.global

Contact No: +91 9043876528+91 9444962691+91 9841580709

Mail: [email protected]

®