welcome to femap and nx nastran v11.2 - applied...
TRANSCRIPT
Welcome to FEMAP and NX Nastran v11.2.2A seminar for new FEMAP and NX Nastran users providing guidance in installation,
setup and running your first analyses.
Adrian Jensen, PE | Senior Staff Mechanical EngineerGeorge Laird PhD, PE | Principal Mechanical Engineer
September 23rd, 2015 Applied CAx Page 2
Installation
September 23rd, 2015 Applied CAx Page 5
September 23rd, 2015 Applied CAx Page 6
Licensing
September 23rd, 2015 Applied CAx Page 7
September 23rd, 2015 Applied CAx Page 8
Analysis Workflow:•Geometry•Material•Property•Mesh Sizing•Meshing•Constraints•Loads•Analyze•Post Process
Your First FEMAP Model
September 23rd, 2015 Applied CAx Page 9
GeometryFile > Import > Geometry
September 23rd, 2015 Applied CAx Page 10
MaterialsModel > Material > ISOTROPIC (7075‐T651)
September 23rd, 2015 Applied CAx Page 11
PropertiesModel > Property > PLATE (0.1”)
September 23rd, 2015 Applied CAx Page 12
Mesh SizingMesh > Mesh Control > Size on Surface
September 23rd, 2015 Applied CAx Page 13
MeshingMesh > Geometry > Surface
Custom Tools > Meshing > Spider Curves
September 23rd, 2015 Applied CAx Page 14
ConstraintsModel > Constraint > On SurfaceModel > Constraint > Nodal
September 23rd, 2015 Applied CAx Page 15
LoadsModel > Load > Nodal
September 23rd, 2015 Applied CAx Page 16
AnalyzeModel > Analysis (36..NX Nastran, 1..Static)
September 23rd, 2015 Applied CAx Page 17
Post ProcessingPost Processing Toolbox (Contour, Deform)
6700 North New York Avenue, Ste 231 Portland, OR 97203‐2836
800‐746‐8134appliedcax.com
Thank you!