Simple, Smart, Effective!Simple, Smart, Effective!

UTG-8UTG-8

Easy as 1-2-3Easy as 1-2-3

Connect the probe Calibrate on a built-in block Switch modes andview readings

11 22 33

Keys legendKeys legend

Switch instrument ON and OFF

Probe zeroing

Run calibration

Switch between Metric and English units

Switch Measure / Scanning modes.Increase current value

Switch backlight mode.Decrease current value.

UTG-8 characteristicsUTG-8 characteristics• Measurement range (steel): 0,63 – 500 mmMeasurement range (steel): 0,63 – 500 mm

• Sound velocities range: 1250 - 10000 m/sSound velocities range: 1250 - 10000 m/s

• Discreetness: 0,01 mm; .001 in; Discreetness: 0,01 mm; .001 in;

1 m/s; .0001 in/us1 m/s; .0001 in/us

• Accuracy: .001 in; 0,03 mmAccuracy: .001 in; 0,03 mm

• Dimensions: Dimensions: 35×70×12535×70×125 mm mm

• Weight: 176 gWeight: 176 g

Probe zeroingProbe zeroing

1 point calibration1 point calibration

Setting of the known velocitySetting of the known velocity

2 points calibration2 points calibration

“MEASUREMENT” mode is used for discrete points measurements. Reading stays onscreen after removing of the probe from the object.

ModeMode « «MEASUREMENTMEASUREMENT»»

Mode Mode ««SCANNINGSCANNING»»

“SCANNING” mode is used for corrosion or other thin areas search. The minimum thickness over all scanning process is displayed after removing the probe from the object.