usg durock™ brand ultralight foam tile backerboard
TRANSCRIPT
USG Tile & Flooring Solutions
USG DUROCKTM BRAND ULTRALIGHT FOAM TILE BACKERBOARD COMPARISON GUIDE
CB772/1-16 © 2016 USG Corporation and/or its a�liates. All rights reserved.The trademarks USG, DUROCK, IT’S YOUR WORLD. BUILD IT., the USG logo, the design elements and colors, and related marks are trademarks of USG Corporation or its a�liates.The trademark SCHLUTER is a trademark of Schluter-Systems Limited Partnership.The trademark WEDI is a trademark of Wedi GmbH.The trademark ICC is a trademark of International Code Council, Inc.
USG Durock™ Brand UltraLight Wedi™ Building Panel Schluter®-Kerdi-Board USG Advantage Foam Tile Backerboard
Rugged Thermoplastic Facer Cementitious Coating Specially Treated Paper Thermoplastic facer delivers exceptional strength, toughness, and an extremely low perm rating.
70 psi compressive strength 36 psi compressive 25 psi compressive Higher compressive strength increases support of tile. Two to three times extruded polystyrene foam core strength polystyrene strength extruded stronger than leading competitor. foam core polystyrene foam core
No washers required Washers required Washers required See above materials cost savings for installation without washers.
0.08 perms per ASTM E96 <1.00 perms per ASTM E96 0.36 perms per ASTM E96 Exceeds TCNA requirements of 0.50 perms for steam showers by six times. procedure E procedure E procedure E
Meets International Building Code Meets UL1715 per ASTM E84 Meets NFPA 286 up to USG meets all code approval requirements. Visit usg.com for more details. Requirements up to 2" thick. 1/2" thick per ASTM E84 NFPA 286, ASTM E84
PRODUCT COMPARISON
0
10
20
30
40
50
60
70
USG Durock™ BrandUltraLight FoamTile Backerboard
Wedi™Building Panel
Schluter®-Kerdi-Board
COMPRESSIVE STRENGTH ANALYSIS (PSI)PERM RATING
0.00
0.05
0.10
0.15
0.20
0.25
0.30
0.35
1.00
Schluter®-Kerdi-Board
Wedi™Building Panel
USG Durock™ BrandUltraLight FoamTile Backerboard
0.08 0.36 70 36 25<1.00
Fastens without washersSaves $2.75 per 4' x 8' panel
Easily waterproof fastener heads with USG Durock™ Brand SealantNo additional membrane patches required, saving $12.50 per 4' x 8' panel
Combines traditional backerboard and waterproofing into one stepSaves time and laborSavings based on pricing obtained fromSchluter® 2015 Illustrated Price List
Schluter® Must use patches over fastenersUSG Simply apply sealant over fastenersSource: Courtesy of Mike Blasko, Creative Tile Eastern CT
INSTALLATION COST COMPARISON
Tested on USG Durock™ Brand and Schluter® 1/2" panels and Wedi™ 1" panels.