usb opto

3

Click here to load reader

Upload: drew-wicher

Post on 25-Sep-2015

7 views

Category:

Documents


0 download

DESCRIPTION

USB Opto-isolator for MAN3000 installation

TRANSCRIPT

  • Technical Information Systems, 2008

    p1

    USB OPTO

    OVERVIEW The Man3000 USB OPTO Isolator is a USB to SERIAL converter with built in OPTO Isolation on both the TX and RX channels. The unit will only work with Man3000 hardware. WIRING The USB OPTO needs four wires to operate. These are supplied on all of the latest Man3000 hardware configurations. Some of our older designs that were made before the invent of the OPTOs do not supply all the connections and may need to be sent to TIS for modification.

    DB25 USB OPTO PIN NAME

    2 RX

    3 TX

    7 0V

    22 + 6V

  • Technical Information Systems, 2008

    p2

    You may refer to the individual product documentation for the specific wiring to an OPTO.

    WORKING HARDWARE REQUIRE MODIFICATION

    Man3000 Standard Karel MS38/48 Internal

    Man3000 Lite Fosonic Internal

    Man3000 Superlite Ver 4 Scanner CPU

    LAN/IP Buffer B4_Remote

    Aristel AVR Internal Man3000 SOFT

    Ver 5 Scanner CPU Dual LAN

    B4_Hymax Internal Panasonic AVR Internal

    B5_DCS Internal

    B5_NX Internal

    DRIVER INSTALATION

    Verify that the wiring is correct Install the latest Man3000 Software onto the PC Plug The USB connector into the PC Windows will automatically find the new hardware and open the driver installation

    window. (Windows 98 you will have to install manually) Direct the driver installation wizard to search in a SPECIFIC location. Direct the wizard to look in the Man3000 directory for the folder USB DRIVERS.

  • Technical Information Systems, 2008

    p3

    Once the drivers have been installed open windows DEVICE MANAGER. Under the PORTS menu you will find CP2101 UART BRIDGE CONTROLER.

    This is your USB OPTO The COM PORT Number in brackets is the Virtual com number that you will set

    the Man3000 Serial port setting to look at. MANUAL DETECTION

    Open Windows CONTROL PANNLE Select the ADD NEW HARDWARE Menu Tell the Wizard to search the PC for new hardware Follow the instructions above.

    ERRORS

    If under Windows DEVICE MANAGER o The CP2102 appears with a question mark. o OR there is no COM PORT number in brackets. o OR The device does not appear at all.

    Then the device will need to be reinstalled.