uputstvo za helikopter
TRANSCRIPT
-
8/20/2019 Uputstvo Za Helikopter
1/8
In this instruction of material, the specification or parts within the accessories bag is for
reference only. The company will not be responsible for any change of printed part and
notify the consumers. Any update or change please refer to the website of SYMA
(www.symatoys.com).
REMOTE CONTROL HELICOPTER
-
8/20/2019 Uputstvo Za Helikopter
2/8
Low-voltage protection: When the helicopter battery is low, the helicopter control system
battery will be protected, and stop the supply of helicopter rotor; low power protection,
the need to charge to secure a new flight of the helicopter.
Overcurrent protection: When the helicopter blades in the rotating state by collision or
jammed, the helicopter circuit overcurrent protection.
1. Please recheck the ground, keep away from the crowds, animals and other barriers.
2. Turn the remote control on, after a while, the LEDs will be flashing. Push the motive handle must be pushed to the maximum control route of travel first, then adjust it to the lowest; When the
remote control LEDs keep lighting, it means the helicopter is going to fly.
3.Open remote control power switch, then the remote status light was flashing and accompanied by
the rhythmic sound, and then push up the up / down variable speed joystick to the top, then its
back to the most low-end; the status of the remote controlThe indicator is lit and the sound stopped,
the remote control to enter the preparatory off state.
4. Push the motive handle slowly, then the helicopter will fly up.
-
8/20/2019 Uputstvo Za Helikopter
3/8
Charging time: can be 60~90 minutes flying about 6 minutes!
电池
First turn off the power switch of the helicopter, "USB cable charging plug to the charging port is
connected to the helicopter, and then" USB cable " The USB end into the USB port of a PC computer
to charge or connect the USB power adapter for charging (USB power adapter sold separately);
charging, USB line indicator lights switch off automatically after charging is completed ; chargingtime is 60-90 minutes.
-
8/20/2019 Uputstvo Za Helikopter
4/8
Remote Control Keypad and LCD Manual
1
2
3
4 5 678
9 1011 121314151617 18
1
2
3
4
5
67
8
910 11
Antenna
Power Indicator
H/L Speed Switch
Left Function Lever
(Throttle Lever)
Power On/Off
Right Function Lever
(Direction Lever)
Turn Lft/Right Fine-tuning
Tail Blade Fine-tuningLCD Manual
Helicopter shows
(Power-on display)
Signal Shows
Normal to full case
Turn Left Shows
(Power-on without display
Throttle shows
(Power-on start in middle)
H/L Speed Shows(Changed by "H/L Speed Switch")
Battery Indicator(According tothe power of batteries)
Forward Shows(Power-on startin the centering)
Turn Right Shows(Power-on without
display)
Tail Blade Fine-tuning(Power-onstart in middle
Backward ShowsPower-onwithout display)
Turn Left/Right Fine-tuning Shows
(Power-on start in centering)
-
8/20/2019 Uputstvo Za Helikopter
5/8
Rotates
Anticlockwise
Rotates
Anticlockwise
Rotates Anticlockwise
Rotates
Clockwise
Rotates Clockwise
In hovering,when the tail
blade rotates clockwise
anticlockwise,please use
this button for fine-tuning
as figure shows.
When the helicopter lose
hovering with automatic
anticlockwise/clockwise
rotation,please use the
right/left inching switch
yo keep balance.
1.Beginner mode (the default setings
low speed)
2.Advanced mode:Press the button
on top left of controller, enter or
exit from the mode. Advanced
mode high speed brings more
pleasure to you
H/L Speed Switch
-
8/20/2019 Uputstvo Za Helikopter
6/8
-
8/20/2019 Uputstvo Za Helikopter
7/8
-
8/20/2019 Uputstvo Za Helikopter
8/8
Transmitter
Problem Cause Check this
No reaction
from the
helicopter
1. Not enough power for the helicoper.2. Not enough power for the controller.3. The channel was different from helicopter and the
controller.4. The gyro of the helicopter can't find out the right
point.
1. the remote control are running low.2. antenna Weld.
1. replace the remote control batteries.2. antenna re-welding.
Not reaction
from the
helicopter
when was fly
S32-01AHead cover A
S32-01BHead cover B
S32-01CHead cover C
S32-02ATail decoration A
S32-02BTail decoration B
S32-02CTail decoration C
S32-05BConnect buckle
S32-11Tail components
S32-13A
S32-17
Motor A
S32-13B
Motor B
S32-14
3.7V Li-Poly
S32-15
Circuit board
S32-16
USB Charger
S32-12A S32-12BTail hold tube
S32-12CMetal frame set
S32-12DMain shaft
S32-06Ascend and descend
S32-07Gear A B
S32-10ABattery case
S32-10BMotor cover
S32-03AMain blades
S32-03BTail blade
S32-04Main frame
S32-05ABalance bar
1. helicopter for charging.2. replace the remote control batteries.3. Close the remote control and the aircraft power supply, re-code.4.The helicopter flat on the ground, re-open the helicopter power until the helicopter gyro re-tested.