the icrf, itrf and vlba chopo ma nasa’s goddard spaceflight center
TRANSCRIPT
The ICRS is the idealized barycentric coordinate system to which celestial positions are referred. It is kinematically nonrotating with respect to the ensemble of distant extragalactic objects. It has no intrinsic orientation but was aligned close to the mean equator and dynamical equinox of J2000.0 for continuity with previous fundamental reference systems. Its orientation is independent of epoch, ecliptic or equator and is realized by a list of adopted coordinates of extragalactic sources.
International Celestial Reference System (ICRS)
The ICRF is a set of extragalactic objects whose adopted positions and uncertainties realize the ICRS axes and give the uncertainties of the axes. Note that the orientation of the ICRF catalog was carried over from earlier IERS radio catalogs and was within the errors of the standard stellar and dynamical frames at the time of adoption. Successive revisions of the ICRF are intended to minimize rotation from its original orientation. Other realizations of the ICRS have specific names (e.g., the Hipparcos Celestial Reference Frame). The current realization is designated ICRF2.
International Celestial Reference Frame (ICRF)
ICRF
• S/X data and analysis through 1995• ICRF-Ext.1, ICRF-Ext.2• 212 defining sources• Position uncertainty ≥ 250 µas• Accuracy of axes ~30 µas• Orientation independent of equator, ecliptic
and equinox
ICRF2
• S/X data through March 2009• 4540 sessions, 6.5 million observations• 3414 total sources• 295 defining sources• Position uncertainty ≥ 40 µas• Accuracy of axes ~10 µas• Orientation independent of equator, ecliptic
and equinox
VLBA Data Very Important
1980
1981
1982
1983
1984
1985
1986
1987
1988
1989
1990
1991
1992
1993
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
0
100,000
200,000
300,000
400,000
500,000
600,000
Contribution of RDVs to IVS Data
RDV T2 R1&R4 Other
Importance of VLBA Sessions
• Impact on ICRF2• 28% of data• improved average position errors by 62% (α) and 54% (δ)• structure mapping (707) for selecting defining sources• densification – VCS (VLBA Calibrator Survey)
• Other astrometric uses of RDV sessions• observe 20-40 requested sources per year• re-observe 30-40 weak sources per year• provide snapshots of 80-90 sources per session - useful for time history
studies
The International Terrestrial Reference System (ITRS)
• The ITRS definition fulfills the following conditions:• It is geocentric, the center of mass being defined for the whole earth,
including oceans and atmosphere.• The unit of length is the metre (SI). Its orientation was initially given by
the BIH orientation at 1984.0.• The time evolution of the orientation is ensured by using a no-net-rotation
condition with regards to horizontal tectonic motions over the whole earth.
•The ITRS is realized by estimates of the coordinates and velocities of a set of stations observed by VLBI, LLR, GPS, SLR, and DORIS. Its name is International Terrestrial Reference Frame (ITRF).
Precision of VLBA Results
Baseline Length Precision:
VLBA baselines have the lower scatterthan non-VLBA baselines especially for long baselines.
Time evolution (relative to mean lengths) of various VLBA baselines. Curvature in last plot is due to antenna tilt at Pietown.
VLBANon-VLBA
HN-FD wrms =3.7 mm
MK-SC wrms = 9.2 mm
KP-PI
mean length = 3,623,021.2526 m
mean length = 417,009.1252 m
mean length = 8,611,584.6972 m
Importance of VLBA Sessions
• Impact on VLBI contribution to ITRF• 28% of data• largest networks - more than twice as large as R1s and R4s• highest precision baselines• improved non-VLBA site position precision by 30%
• Other geodetic uses of RDV sessions• supports monitoring of VLBA positions at 1-2 mm, sub-mm/yr• highest precision EOP measurements – information for FCN
VLBI 2010
• Current geodetic network: dual frequency S/X band– S-band delays contribution down by factor ( 8.4/2.3 )2 – Only need to concentrate on X-band source structure
• For VLBI 2010 – 24/7 operations– Reduced stochastic errors (i.e. troposphere, thermal,
clock drifts)• Source structure delay becomes more important
– 2 - 12 GHz feeds with four ~1 GHz optimally spaced bands