indoor / outdoor

ASSEMBLY INSTRUCTIONS

GENERAL

Thank you for choosing the Teqball One table. We would like to give you some advice for the assembly. Please read and follow these instructions carefully.

SAFETY NOTICE

ASSEMBLY

The Teqball One table must be assembled by at least two adults following the numerical order of the assembly instructions. Before assembling, please check that all the proper parts are contained in the packages. The indicated quantities of parts make it possible to go through the assembly stages. Use the tools recommended on page 5.

IMPORTANT: Assembly should be carried out on a clean, dry, level surface. Please ensure there is nothing on the floor that could scratch the tabletop. During the assembly put the packages to the ground and hold the parts above them to prevent the damage that is caused by falling or impact. During assembly remove the protection foil from the PMMA net and from the tabletop.

Any person handling or using the Teqball One table must follow the instructions as described in this document. The person in charge of assembling and using the Teqball One table must ensure that the recommendations for use given in this document and in the Owner's Manual of the Teqball One table are seen by all users. In communal use, it is strongly recommended that the instructions and diagrams are displayed.

Only use the Teqball One table after it has been fully assembled and after checking that the screws are tightened properly. Later, depending on frequency of use (but at least twice a month) check all screws regularly to ensure that their condition is good. The fasteners are coated with adhesive which is inactive until the coated fasteners are used. During assembly the adhesive is activated. The adhesive can prevent the self-loosening of fasteners, but the effect of the adhesive decreases with every assembly. Please do not remove the adhesive from the fasteners.

Assembly must be carried out at least by two adults during all stages.

2

ASSEMBLY REQUIRES AT LEAST 2 ADULTS!

TIGHTENING TOOL

TIGHTENING

TIGHTEN COMPLETELY STOP HALFWAY

KEEP THE TABLE HORIZONTAL

BE CAREFUL TO AVOID INJURIES! IF STUCK, TRY MOVINGTHE PARTS GENTLY!

3

3000

mm

1500 mm

147 kg

PLAYING SURFACEPACKAGE

118 kg

1620

1605

320

78 kg

2225 700

300

4

1x

1x

6

2x

1x

1x1x2x

1x

2x

2x

2x

M8x85

F1

F2

F3

F4

F5

M10x25M8x75

6x6x

8x

12x

D8M10x35

4x

C2

C1C3 C4

C5

C6

C7

C8

C9

purple blue(turquoise)

yellow green

5

6

8x

21

3 4

F4

!

!

!

!

C2 C2C3

C4

C1

C1

6

6

6

5

7 88/1

8/2

6

3x F5F2

3xF5F1

!

C5C6

C7

C6

C5

C8

7

6

6

3x 3x

109

11 124x F3

F5F13xF5

F23x

!

C8

C9

10/210/1

8

6

6

6

6

3x 3x

Remove the protection foil of the net and the tabletops

before assembly.

13

14

3xF5F1 6x

F5F2

3xF5F1

CHECK ALL FASTENERS!

9

6

6

15

DONE!

10

ENJOY TEQSPORTS!

11

Further information

www.teqball.cominfo@teqball.com