Asif Haider

Habib Awan

OPTIMIZATION

Optimization is intended to provide the

best network quality using available

resources as efficiently as possible

INTRODUCTION TO TEMS

• Drive testing is the most common and

maybe the best way to analyze Network

performance.

• Drive testing is basically recording

measurement data which can also be

analyzed afterwards.

• It gives idea about what’s happening with

a subscriber point of view.

CONTENTS

The information provided by TEMS is displayed

in status windows. This information includes

• cell identity, base station identity code, BCCH

carrier ARFCN, mobile country code, mobile

network code and the location area code of the

serving cell.

• There is also information about RxLev, BSIC and

ARFCN for up to six neighboring cells;

CONTENTS

• channel number(s), timeslot number, channel type hopping channel indication, mobile allocation index offset and hopping sequence

• RxLev, RxQual, FER, DTX down link, TEMS Speech Quality Index (SQI), timing advance (TA), TX Power, radio link timeout counter and C/A

• parameters for the radio environment.

• The signal strength, RxQual, C/A, TA, TX Power, TEMS SQI and FER of the serving cell and signal strength for two of the neighboring cells can also be displayed graphically in a window.

USING SOFTWARE

• Tailored settings

• Default tabs

• Basic windows

• Maps—gst

• Recording properties

• Exporting log files

• Report generation

ANALYSIS OF LOG FILES

Analysis is the most important part. Lets

look at some of the cases.

• Dropped call - Nbr not defined

• Dropped call – RL Timer expires

• HO Failure

Lack of Dominant Server

Signals of more than one cell can be

reaching a spot with low level causing ping

pong handovers. This might happen

because the MS is located on the cell

borders and there is no any best server to

keep the call.

Drop Call due to Bad Coverage

• Call is dropped because of poor coverage.

• The signal level goes down below the

minimum signal level that system could

carry on

Bad Quality due to Signal

Strength

• FER is Bad

• FER is good implies no obviuos

interference in the area.

LAYER 3 MESSAGES

Layer 3 Messages

• SYS INFO

• Measurement Reports

• Sync Messages

• Paging Messages

• Handover

• Call Setup

etc

IDLE

DEDIC

Measurement Reports

SYNC CHANNEL INFO

Paging Request Message

QUESTIONS

• REFERENCES

• TEMS Log File Analysis

• ARI-Nortel

• Nokia BSS parameters