TEMS 8 .2 .1 Bas ic Steps

Presentation-gsm Positioning-mapConfiguration-general-load Cell File

Logfile-recording Properties-desktop-new Folder-ms1 Dedicated Name Of Folder-all Log Files In It ,Idle,dedicated Both

Map-theme Setting-cell Layer-cell Theme-cell Label Add

Layer Properties-give Route Of DT Add

GPS Attach-f2 Connect

Mobile Attach:

Msi-connect-dedicated,ms2-connect-idle(f2),ms3-connect In Scaning Mode(ms3-scanning-properties(decode Bsic-check Mark,write 42-64 Ufone Channels)-start

Control-command Sequence-edit-voice-dial-give Values-(time Interval=90sec)

Drive Start------------------------------------------------------------------------------------------------------------

Record-(save Log File)-run –Stop Recording……in Each Route Do This Stp-remove Mobile

Log File-export Log File-add Input File(log File Where We Save)-add All Log Files-output-merge Output-prefix-ms1 Dedicated-run

Now Mapinfo File Generated

Log File-report Generated-add All Log Files/Report Generated KPI

Layer 3 Messages=rf(air Interface) Messages Like Synch Channel ,Paging Channel Request Info Etc

Layer 2 Messages=events Like Call Established, Call Setup Etc

Mode Reports=ul/DL Measurement Reports