OverviewThe Tellabs® 7305 and 7307 Ethernet Demarcation Devices (EDDs) are flexible and cost-effective Network Interface Devices (NID) that can operate as a Transport NID or Service NID to provide service demarcation for in-franchise and out-of-franchise applications. They include the standards-based performance and Operations, Administration and Maintenance (OAM) features that network operators need to successfully transport and deliver Carrier Ethernet services.

The Tellabs 7305 and 7307 EDDs are part of the Tellabs® 7300 Metro Ethernet Switching Series and an integral component of Tellabs® Carrier Ethernet Solutions. By combining the Tellabs 7305 and 7307 EDD with the Tellabs® 7100 Optical Transport System (OTS) and the Tellabs® 8600/8800 Smart Router Series, operators can design, scale and deliver cost-effective and reliable networks that meet users’ varying service needs. The 7305 EDD can be managed by the Tellabs® 8000 INM as part of a larger Tellabs solution. This provides end-to-end provisioning and support.

Featuresn Functions as a Service NID or Transport NIDn Supports 802.3ah Link OAM and 802.1ag Service OAM for

end-to-end fault detection and performance monitoringn VLAN service tagging (802.1Q)n E-Line and E-LAN and E-Access service multiplexing via

802.1ad VLAN stacking (Q-in-Q)n Granular rate limiting using Committed Information Rate (CIR)

and Committed Burst Size (CBS) n Class of Service based on 802.1p Quality of Service (QoS)

prioritizationn Small Form Factor Pluggable (SFP) Gigabit and Fast Ethernet

fiber transceivers for standard and Coarse Wavelength Division Multiplexing (CWDM) applications

n Customer-facing service port available in copper RJ-45 (7305 only) or SFP fiber interfaces

n Temperature-hardenedn Certified MEF 9, MEF 14 and MEF 21 Compliantn MEF 30 and MEF 31 Compliantn G.8031 Ethernet Linear Protection Switchingn G.8032 Ethernet Ring Protection Switching*n Zero touch provisioningn Service activation testing with RFC 2544 (7305C/D, 7307C/D)n Carrier Ethernet 2.0 Certified by the MEF 1/29/2013 (E-LAN,

E-Line, E-Access and E-Tree)

n Flexible management options with command-line interface, Tellabs 7191 Craft Station, and Tellabs 8000 Integrated Network Manager (INM)

When functioning as a Transport NID, the Tellabs 7305 and 7307 EDDs act as a remotely managed media converter with carrier-grade OAM capabilities. Tellabs 7305 and 7307 EDDs are service-transparent and passes data without performing traffic management. Traffic management functions are performed by carrier equipment at the edge of the service provider network.

As a Service NID, Tellabs 7305 and 7307 EDDs provide service mapping and traffic policing and shaping functions. Tellabs 7305 and 7307 EDDs support MEF-certified User-to-Network Interface (UNI) functions, including Class of Service (CoS) prioritization, granular rate-limiting and 802.1ad Provider Bridge VLAN stacking (Q-in-Q) for service multiplexing of multiple E-LINE and E-LAN services.

In both operational modes, the Tellabs 7305 and 7307 EDDs conform to the latest carrier-class Ethernet OAM standards — 802.3ah Link OAM proactively monitors the network provider’s fiber access and customer-facing links for physical failures and deterioration of data quality, and 802.1ag Service OAM provides end-to-end Connectivity Fault Management (CFM) and performance monitoring. These OAM features provide efficient detection and rapid isolation of potential service problems to provide Service Level Agreement (SLA) assurance while reducing Operational Expenditures (OpEx).

Tellabs® 7305 and 7307 Ethernet Demarcation Devices

Tellabs® 7305 and 7307 Ethernet Demarcation Devices

DATA SHEET

See tellabs.com for more information about Tellabs Solutions

Compact 1 Gigabit Carrier-Class Ethernet Transport and Service Delivery.

* Supported by upcoming release

Figure 1: Tellabs 7305 and 7307 EDDs in geo-diverse and multi-tenant applications

Metro EthernetNetwork

CPE

CPE

100Mbps or 1000MpbsFiber Access Links

100 Mbps/1000 Mbps Fiber

UTP Copper

7307

7305

The Tellabs 7305 and 7307 EDD fiber ports can support Gigabit (1000 Base-X) or Fast Ethernet (100 Base-FX) fiber access links by utilizing an SFP transceiver with the desired data rate. The triple-speed copper interface operates at 10/100/1000 Mbps rates. The Tellabs 7305 EDD may be used in two-port or three-port configurations. In the three-port configuration, the Tellabs 7305 EDD can be used in geographically diverse uplink redundancy applications and multi-tenant applications (Figure 1). The five-port Tellabs 7307 EDD can support redundancy to the CPE as well as geographically diverse redundant network connectivity.

Ethernet

nThree-port and five-port configurations support redundant access link or multi-customer applications

nInterfaces – 1 x 10/100/1000 Mbps electrical (RJ45) (7305) – 2 x 100/1000 Mbps optical (SFP) (7305) – 5 x 100/1000 Mbps optical (SFP) (7307) – 10/100/1000 Mbps electrical (RJ45 SFP) – All ports are configurable as NNI or UNI nSFP transceivers for standard or CWDM wavelength nSFP transceivers models support maximum fiber distances

up to 140km nG.8031 Ethernet Linear Protection Switching nG.8032 Ethernet Ring Protection Switching* nMedia conversion for connectivity to customer equipment nSupports 10,240 byte jumbo frames nSupports Rapid Spanning Tree Protocol (RSTP)

Fault ManagementnSupports a variety of link fault detection and fault

propagation features – Link fault notifications – Link/VLAN RDI (T-RDI and 802.1ag RDI) – Link fault propagation over port level service via

automatic laser shut off

n802.3ah Link OAM – Link loopback – Unidirectional link fault detection – Threshold-based monitoring and notification – Dying gaspn802.1ag end-to-end Service OAM and CFM – Supports eight levels of Maintenance domains

and Maintenace End Points (MEP) – 64 Maintenance Associations – Connectivity Check Messages (CCM) – Remote Defect Indication (RDI) – Link Trace – Diagnostic loopback (Layer 2 ping)nY.1731 Alarm Indication Signal (AIS)nSub 50ms Failover Protection Switching

Traffic ManagementnService mapping to enable multiple services per UNI – 802.1Q VLAN tagging – 802.1ad Provider Bridge VLAN stacking (Q-in-Q) – Service Multiplexing up to 64 Ethernet Virtual Connections

(EVCs) for E-line, E-LAN, and E-Access Services – Layer 2 control protocol policy (L2CP) managementnTraffic policing and shaping – Granular rate limiting – CIR & CBSnCoS based on 802.1p QoS prioritization

Node Management & SecuritynFlexible management tools: – Command Line Interface (CLI) – Craft station GUI (Tellabs® 7191 Craft Interface) – Tellabs® 8000 Integrated Network ManagernSecure Shell (SSH)nRemote management – In-band VLAN – SNMPv1/2c/3 – Telnet – IP-less 802.3ah OAM extensionsnLocal management via serial console portnPublic (non-proprietary) 802.1ag CFM SNMP MIBs – Easy third-party SNMP management software integration

2 TELLABS 7305 AND 7307 ETHERNET DEMARCATION DEVICES

See tellabs.com for more information about Tellabs Solutions

* Supported by upcoming release.

Specifications

Performance Testing & MonitoringnY.1731 Performance Monitoring – Frame delay – Frame delay variation (jitter) – Frame loss – Service availabilityn RFC 2544 Network Performance testsnY.1564 Service activation tests*

Synchronizationn 1588v2 Precision Time Protocoln Synchronization Ethernet*

Physical and EnvironmentalDimensionsn 25mm x 97mm x 122mm / 1.0" x 3.8" x 4.8" (H x W X D) (7305)n 34mm x 122mm x 152mm / 1.325" x 4.8" x 6.0" (H x W X D) (7307)Weightn 1.5 lbs. (0.68 kg), including AC power adapterTemperature & Humidity n Available for Normal and Extended operating temperature

range environments – 0°C to 50°C (7305A/C) – -40°C to 75°C (7305B/D)Storage Temperaturen -40°C to 80°CHumidityn 5% to 95% (non-condensing)

Power Specificationsn 8-32V DC (7305A/B), 8-60V DC (7305C/D), 10-60V DC (7307C/D)n 100-240V AC (50 - 60Hz) with adapter (included)

Regulatory/Compliancen FCC Part 15, Class An UL 60950 1st Editionn IEC 60950n CSA C22.2 60950n NEBS Level 3 Compliantn RoHSn WEEEn MEF 9, 14, 21 Certified Compliantn Carrier Ethernet 2.0 Certified by the MEF 1/29/2013 (E-LAN, E-Line,

E-Access and E-Tree)n MEF 30, 31 Compliant

3 TELLABS 7305 AND 7307 ETHERNET DEMARCATION DEVICES

North America

Tellabs1415 West Diehl RoadNaperville, IL 60563U.S.A.+1 630 798 8800 Fax: +1 630 798 2000

Asia Pacific

Tellabs3 Anson Road#14–01 Springleaf TowerSingapore 079909Republic of Singapore+65 6215 6411Fax: +65 6215 6422

Europe, Middle East & Africa

TellabsSuites 1 & 2St Johns Court Easton StreetHigh Wycombe, BucksHP11 1JXUnited Kingdom+44 871 574 7000Fax: +44 871 574 7151

Latin America & Caribbean

TellabsRUA James Joule NO. 92 EDIFÍCIO PLAZA I São Paulo – SP04576-080 Brasil+55 11 3572 6200Fax: +55 11 3572 6225

The following trademarks and service marks are owned by Tellabs Operations, Inc., or its affiliates in the United States and/or in other countries: TELLABS®, TELLABS and T symbol®, and T symbol®. Statements herein may contain projections or otherforward-looking statements regarding future events, products, features, technology and resulting commercial or technological benefits and advantages. These statements are for discussion purposes only, are subject to change and are not to be construed asinstructions, product specifications, guarantees or warranties. Actual results may differ materially.

© 2013 Tellabs. All rights reserved. 74.2061E Rev I 6/13

Feature 7305A 7305B 7305C 7307C

7305D7307D

TELNET, SNMP v1, v2c, v3 x x x x

SSH -- -- x x

Zero-Touch Provisioning x x x x

ITU-T Y.1564 Service Testing -- -- * *

RFC 2544 Throughput Testing -- -- x x

IEEE 802.3ah x x x x

IEEE 802.1ag x x x x

ITU-T Y.1731 x x x x

EP-Line, EP-LAN, EP-Access x x x x

EVP-Line, EVP-LAN, EVP-Access x x x x

Rapid Spanning Tree Protocol x x x x

G.8031 Protection -- -- x x

G.8032 Ring Protection -- -- * *

Rate Limiting x x x x

MIB Statistics (RMON) x x x x

L2CP Policy Manager x x x x

Sync Ethernet -- -- * *

Dying Gasp x x x x

Temperature Hardened -- x -- x

L2PT (STP, VTP, CDP protocols) -- -- x x

1588v2 PTP -- -- x x

Carrier Ethernet 2.0 -- -- x x

* Supported by upcoming release.