team : stephanie long nina wong sara wilson diana shelby
TRANSCRIPT
Team:
Stephanie LongNina WongSara WilsonDiana Shelby
The purpose of our Rube Goldberg machine:› Raise a banner› Trigger another
team’s machine We used materials in
our room and things we found in Estabrook 13 to create our machine. The cost of Bake Me A Cake is approximately $18.65
Bake Me A Cake starts by pulling a string that rotates a wheel with a ball inside. The ball is then released onto a ramp which directs the ball into a cup hanging from a pulley.
The pulley will then trigger two reactions:› Releasing the hinge below the coffee pot to
trigger the blender which will raise the banner.
› Pull the egg beater from beneath the ramp to allow a ball to roll onto another teams machine.
Torque› Wheel› Pulley› Blender› Coffee Pot
Angular Momentum› Coffee Pot› Wheel› Ramp
Projectile Motion› Ball onto ramp› Ball into cup
Center of Mass› Final Ramp
Translational Kinetic Energy› Ball rolling
Linear Momentum (Collision)› Ball into cup ->
inelastic
Translational Kinetic Energy› Ball rolling on ramp› Mgh= ½ mv2
(32.2 ft/s2)(.458 ft.)= ½ v2
V=5.433 ft/s
Torque› Ball, Pulley, and Cup› Torque=Frsin Θ
τ=(.0625lbs)(.0521ft)sin(115˚) τ= .00295 ft-lbs
Problems we came across..› The blender wires connecting to the switch
became undone each time we put it away.› Making sure the wheel turned completely
to drop the ball Building B-MAC was a lot of fun and a
lot of work! But the end result was worth our effort.