sunbird v2.0 balsawood airplane instruction...
TRANSCRIPT
Sunbird Instruction ManualV2.0 Balsawood Airplane
Suggested Equipment Motor: MM2212 1100KVESC: 20APropeller: 8 inch folded propellerServos: 9g*4Battery: 3s 800-1300mAhRadio≥4CH
Speci�ication Wingspan: 1600mm Length: 850mm Flying Weight≈450-650g
Preparation Tool
F1
F2F3
F15
F19
F14
F5
F6
F7
1.2
1.3
1.4
1.5
Take down and assemble the wood pieces of fuselage as per the following picture,connect the joints by 502 glue.
Cut the balsa strips with actual length,assemble them in place as pitcture shown left;Assemble in the same way the other side.
Paste the F1 and F2 together,and fasten the joint with F3.
Paste the F5 and F6 together,and fasten the joint with F7.
3*4mm balsa strips
1.Fuselage Assembly
Accessories include
Sunbird Instruction ManualV2.0 Balsawood Airplane
F9
F9F12
F11
F10
F8
F4F16
F13
Magnet
Magnet
Assemble the tail as per the 1:1 plan,and take care of the straightness of the tail.
Paste the finished board (picture 1.5 above) at the bottom of the fuselage.
Assemble the cabin cover as picture shown left.
Paste the cover F4 and F8 as picture shown left,paste the servo mount base F16.
Assemble the vertical and horizontal tail at the tail of the fuselage,connect the two ailerons with U-shape steel wire.
1.6
1.7
1.8
2.1 2.2
2.3
U-shape steel wire
2.Assembly of Wing and Tail
Sunbird Instruction ManualV2.0 Balsawood Airplane
Assemble the wing as per the 1:1 plan,and take care of the straightness of the wing.
Paste the balsa cover onto the wing.
Assemble the connection part W20,connect and glue the two parts of the wing together.
Assemble the left and right wing,connect both with the carbon tubes as picture shown below,glue at the joints.
2.4
2.5
2.6
2.8
W26
W28-1 W28
W20
W27W27Paste the W17 on the wing as picture shown,cut and polish by knife with curve.
Cut the balsa strips with actual length,assemble them in place as pitcture shown below;Assemble in same way the other wing.
2.9
2.7
Sunbird Instruction ManualV2.0 Balsawood Airplane
Assemble the wing onto the fuselage,drill a hole on the wing as per the F17 position,finally fasten the wing with screw.
Paste together the F17 and F18,assemble the nut onto the F18.
F18
F173.1
3.2
3.3
3.4
C.G≈56mm
3.Assembly of Wing and Fuselage
Assemble the finished part (picture 3.2) onto the fuselage.