sr firmware update using lectrolink - … service department sr firmware update using lectrolink...
TRANSCRIPT
LECTROSONICS SERVICE DEPARTMENT
SR Firmware Update Using Lectrolink
CLICK YOUR MOUSE OR USE THE ARROW KEYS TO ADVANCE THROUGH THE
TUTORIAL
Newer generation Lectrosonics wireless products are equipped with a serial port for updating Firmware using the Lectrolink Firmware & Programming Interface. The following tutorial applies to the SR,SRA & SRA5P model receivers.
SR Firmware Update
SR Firmware Update
USB Cable
LecNet2 Software
Lectrolink Cable
All items shown are included with the Lectrolink interface kit.
What you will need for the job
Lectrolink
Load LecNet2 Software into your Computer SR Firmware Update
Insert the LecNet2 CD in your computer and follow the instructions for loading the software.Be sure to uninstall any previous versions ofLecNet2 software before installing the latestversion.
You can also download the software from www.lectrosonics.com at the following link.
http://lectrosonics.com/lecnet2/lecnet2.htm
If your SR Receiver is slot mounted using either the SRUNI or SRSNY Power adapters, then you will need to wire your Power Adapter for external power. Refer to the pin out diagrams below for wiring yourAdapter. The SR receiver requires a minimum of 6V and a maximum of 18V DC power.
SRUNI SRSNY
Powering the SR Receiver SR Firmware Update
Remove the Receiver from the Housing.
1. Remove the 4 screws (prt# 28869)Attaching the Power Adapter andControl Panel to the Housing.
Prt# 28869
2. Slide the receiver out from the Housing.
SR Firmware Update
Set the Receiver to Update Mode
Getting the SR receiver into Update mode can be tricky but it can be done. You may need the help of a second person if you are unable to do both functions.
1. Hold down both arrow buttons. 2. Apply power to the Receiver byplugging the power adapter into the unit (while holding down the arrow buttons).
Note: Attempting to power up the unit from the front panel while holding the arrow buttons will NOT get the receiver into “Update” mode.
Receiver in Update Mode.
SR Firmware Update
Connect Lectrolink to your Computer
1. Plug the USB Cable into your computer.
2. Plug the opposite end of the USB cableinto the Lectrolink.
SR Firmware Update
Connect Lectrolink to the SR
Plug the Lectrolink cable into the Serial Port.
Insert the cable with the Red and Green wiresMatching up with the letters (R & G) marked onThe Circuit Board.
R
G
SR Firmware Update
Launch Lectrolink Utility
Once installed, launch the LectroLink utility by navigating to the menu, as shown above. The typical file path is:Start >All Programs >LecNet2 >Tools >LectroLink Utility
After installing LecNet2 software and launching the LectroLink Utility, refer to the help files for assistance with USB driver installation and operating the LectroLink. Access the help files by clicking on the “Help” button in the LectroLink utility. The help button is located at the lower right of any LectroLinkutility window.
SR Firmware Update
Update Firmware
1. Choose Activity - Select “Update a Wireless devices Firmware”. Click (Next)2. Select Adapter - Select Lectrolink fromthe list. Click (Next) 3. Prepare Device to be Updated - Confirm the SR is connected to the Lectrolink and the receiver is in the “UPDATE” mode. Click (Next)4. Select Update File - Locate the firmware file with the extension “.hex” on your computer by clicking the (Browse) button. After selecting the file ,Click (Next)Contact Lectrosonics for latest firmware version.
sra v1_4.hex5. Proceed with Firmware Update - Click the “Start Update” button. Click (Finish) when completed.