soundboard gembird sc 5.1 1_manual
TRANSCRIPT
-
7/30/2019 Soundboard Gembird SC 5.1 1_manual
1/7
5.1 channels sound card
SC-5.1-1 5.1 channels sound card
-
7/30/2019 Soundboard Gembird SC 5.1 1_manual
2/7
-
7/30/2019 Soundboard Gembird SC 5.1 1_manual
3/7
5.1 channels sound card
Introduction
Thank you for buying the Gembird 5.1 channels sound card! This manual will help
you install and use it properly.
Features 2/4/6 channel speakers mode. Supports 2/2.1/4/4.1/5.1 speakers Full-duplex playback and recording Superior audio f idelity High quality headphone amplif ier Enhanced microphone input sensitivity
SC-5.1-1User manual
-
7/30/2019 Soundboard Gembird SC 5.1 1_manual
4/7
5.1 channels sound card
Specifications
Supports 6 channel output Fully compliant with AC97 Revision 2.3 Superior audio fidelity Independent 20 bit ADC and 20 bit DAC Provide 96K/20 bit Multi-channel analog output High quality headphone amplifier Enhanced microphone input sensitivity 4-bit 3D depth control Channel swapping Supports EAPD control PCI Rev. 2.2 compliant with bus mastering modes ACPI compliant power down management Chipset VT1723+1617
-
7/30/2019 Soundboard Gembird SC 5.1 1_manual
5/7
5.1 channels sound card
System requirements
Windows 98SE/ME/2000/XP/Vista DirectX 8.1 or above
Sound card layout
-
7/30/2019 Soundboard Gembird SC 5.1 1_manual
6/7
5.1 channels sound card
The rear panel of card has the following jacks:
1. Mic In2. Line In3. Line Out4. Surr Out5. CEN/LFE6. J10 Analog CD|IN Port (Signals: L-G-G-R)
-
7/30/2019 Soundboard Gembird SC 5.1 1_manual
7/7
5.1 channels sound card
Installation
Locate an available PCI slot on your computer, and insert the 6 Channel SoundCard into the slot. Fasten the card to the case using a screw
Start your PC. Windows will detect the Sound Card, find a PCI MultimediaAudio Device or Multimedia Audio Controller device. Click the Cancel button
to cancel the driver installation for the device at this moment
Place the Driver CD into the CD-ROM drive and start setup.exe on it, if theinstallation is not started automatically
Follow on-screen instructions to complete the software installation Restart your system