SCHOOL WOMEN WORK HAND

VYDÄYANÁ CLUBS IN PRAGUE TEACHERS,

supervised by

Komitet LADY OF THE DOZÍRÁNI VYUÉOVANÍ industrially IN GENERAL AND THE CZECH GIRLS PRAGUE MĚŠŤANSKÝGH

ŠKOLAGH.

Editor: ANNA SRBOVÁ~LUŽICKÁ.

Collaborators:

Růžena, Bartoničková, Barbora Öervenková, Blažena. Erbonová., Božena; Fialová.,Bohumila Klimešová., Karolina Kreìmlová., Marie Kređbová., Barbora Lebedová., Josefa Müllerová, Julie Polılován

Volume čfvrtý: UZLOVATINA.

(With pictures.)

PRAGUE EXPENSES KARLA BELLMANNA

1881

UZLOVATINA.

SECTION FOUR WOMEN SCHOOLS WORK HAND

Written by:

Editor:

ANŇA SRBOVÁ-LUŽICKÁ,

AND CONTRIBUTORS BARBORA ČERVENKOVÁ, BOHŮMILA KLIMEŠOVĂ, ĚJULIE

POHLOVÁ.

PRAGUE.

EXPENSES KARLA BELLMANNA 1881

b) Oka, this looks rough, but it is a much faster and less labour in

the work than the previous one. But what is especially commendable for them to be more

diverse patterns and give them to constitute the nodes in them are stejnější. He never works more easily and are very understandable, and each worker knows háčkovati.

We need them, yarn and hook.

Yarn.

The thread apply all we have said on drhaných.

Hook.

Elect Hook It should always be a sweetheart and stronger than

thread. Furthermore, we look to be anywhere as strong to handle, as is the hook, which we use in Turkish, and herringbone tamburování, then that was long, as many knots with him and then pushes nahazuje.

The images that we present, we serve such a hook as the

thickness increased significantly, it causes a clearer view.

Implementation.

As in drhaných are always there for us and two loops one node. We keep the following: prepare the first eye when hacking as

an ordinary, hold the hook in his right hand, put the thread between the ring finger and little finger left hand toward you and těmitéž, sticking her fingers, then make it loop around the index finger and from front to rear , formed into a loop injects a thread from the front left hand to right, run the loop with your finger and pulled.

Thus, we made a loop from the front, and the first knot. Now, without a thread released, we will loop again, but in the opposite direction ie from rear to front and rear thread again from left to right hand to hook it straight away, as he had the loop with your finger, run it and pulled. Thus, we made a loop from the back and along the second bundle.

A clear overview of such loops and nodes is made, we figure no. 18a).

Both knots are one binary bundle. Picture no. 18a). Geminated bundle. If we have a sufficient number of nodes already done, join

them in a circle. This is happening: the hook nahodíme thread about 4-5 cm from the nodes, as in the picture no. 18 b) is depicted, and withholding a number of tight junctions with the thumb and index finger of his left hand.

Picture no. 18 b). Council knots. Loop sticking with it and hook - hook upside down - is brought

up off the thread slipped by all nodes. Picture no. 18 c) shows us the number of nodes threading.

Picture no. 18 c). Threading line.

Joining the ring.

Now is our connect one end to another in the ring. It happens

this way: the eye, which are stretching arose, let the hook and loop stabs at last made-knots, which is outlined in the image no. 19th arrow, then nahodíme once on a hook and eye the rose also stretch the loop to the hook eye,

Picture no. 19 Joining the ring.

otherwise we can also připojovati two mA ring chain mesh, both

in image no. 19th obvious, that we will be first chain mesh zachytivše thread from the other end, only then injects the mounting ring will last a loop knot, the arrow indicated, and the second lip. eye immediately.

This zhoíovily ring and we are the first to start the second, we make three or four chain mesh and then work again as a ring first. So with all the other rings. But if the individual rings between připojovati work together, we make the second ring ahead just a part of the picture as no. 20th see, for example, then deduct 3 to 4 knots - the knots and likewise, what we present on this part zhotzovily - adjacent to the pnvniho ring from the end and the site of the first half following a node make a lip. eye to the outer loop of the first node so calculated and lip ring. eye the ring with you.

Picture no. 20. Connecting ring.

Dodělavše second half of this node, we continue to work the second ring in the usual sorting, regardless of this connection. Likewise, starting in the third ring and td

Picots

As the meshes are drlıaných pikoty special decoration work

well here. It is made very easy when nodes at a distance of NEB ½ cm or more apart zadrhujeme, allowing us more free loop, and then rise up in knots sešoupnutí NEB in pikot withdrawn in ring form, as the image no. 21st You can know them clearly.

Picture no. 21 Picots.

If such pikotů in one ring to be more, eg, 7, decorate the outer side. In this case the starting like this: we will first 6 knots, then do seven of spades. and between every two nodes in seven of spades. 5 knots again, and then all of a single ring immediately.

In the picture no. 22 we see more such times in the same circles and connected to a separate account for lace. We note that the rings are linked with each other seven Ret. mesh, and in each subsequent ring on the first point of connection pikotu is only one lip. eye through posleđni pikot extended to the preceding ring, then that we already pikotů labor in just 6 left.

Picture no. 22. Slicer.

If produce such rings five times, with the difference between each of them instead of seven Ret. ok 3 Ret. eye and then do all 5 in a circle together will receive a rosette, from which different patterns can be re-build, as all of the rings.

Type pikotů large, which is a long chain zdobívají arches. As such we will usually always bend a sweetheart, then

nahodíme 6-7 loops from the front, while all those yarn loops stretch, and then I finish the second half of the bend.

PolokrouŜky.

And these shapes are beautiful roses assemble, which they always look jagged. These are made as follows: We start as usual: for example, do 4 knots, thread sorting nodes in the usual stretch, but without them in a circle together, then nahodíme same number of nodes in the beginning with you all as previously, and repeat it as many times as we are going to create a half-rings. Since each half rings have to hook one eye.

Picture no. 23

Now nahodíme and brought up through all the rings simultaneously slipped. Picture no. 23rd shows us such rings of five, has already prepared the rose: the first of these three knots are made, the other 4 to 5 third, the fourth 4, the fifth again, only 3, then we combine the 5 half-rings in the rosette, we find the middle one is largest.

Just seřadením such roses together and combining them fifteen Ret. mesh, we get a very tasteful lace.

But then the 'kraječce this, which rose lip. rings are connected in series, where one row of Ret. alternately mesh with multiple columns in arcs řetízkových obháčkujeme to get straighter lace around the county. Řetízkových nahazuje mesh during the five and five middle lip. mesh bend always making 5 short posts.

In the picture no. 24th counting is a very strong yarn and are pleased that the staff always made the first polokroužek 5, the second 6, the third 7-8, again on the Fourth of 6 on the fifth of 5 knots.

Circle circle stitch.

We'll ring familiar sorting, only that a larger number of nodes need to be 30 When we finished it, put a circle on the hook, sticking to him in that position uhačkujeme 6 Ret. OK, while the new 30 knots on the second ring,

Picture no. 24. Circle Circle stitch

then thread the usual sorting and slipped all the nodes at the

same time ring out, and here only the second ring immediately. The image no. 24th We see many such circles the top of the obháčkovanou, and she also are not very nice, but firm and lace. The circles are not circles proplétaných nice roses and sestavovati patterns.

As regards the general pattern, the same applies here, when we said the drhaných meshes, and therefore only serve once again sorting samples of each heading.