8/16/2019 s Series Proximity Switch-rotary Encoder Rj Series Rotary Encoder

1/1

www.mypinchina.com

SSR单相 三相固态继电器

S series Proximity Switch/Rotary Encoder RJ series Rotary Encoder 

Features

41

⊙Photo-electric rotary encoder is a digit sensor integrated with light,electricity and machine,

  no machanical contact among coded wheels,with high rotary speed and long use life;

  especially suitable to movement occasions.Widely applicable to irrigation,CNC machine,

  textile,eletricity,aircraft,metallurgy,petroleum,chemical and light industry,measuring rotations

and displacements precisely,various interfaces selectable;

Code Illustration

Signal Output：(only to absolute encoder)

  A：4-20mA standard analogue value

  C：serial output RS485

  S：synchronous serial interface SSI

Output state:Blank:open-collector output

  E：voltage output positive logic（when the high level is“1”）

  F：voltage output negtive logic（when the low level is“0”）

  K：switch contact output

 

Output Mode:H: air-plug in the back

  C: air-plug in the side

  Y: cable in the back

  G: cable in the side

Incremental mode：Blank: anticlockwise

S: clockwise

 

Working Voltage: A:5V B:5-12V C:12-24V

Pulse Output：50,100,200,1000

Shaft Diameter ；φ8 φ8 φ10

Order Mode：RD：Photoelectric Absolute Encoder 

  RJ：Incremental Rotary Encoder 

Note:Signal output offers various inferce mode for choices so as to facilitate to connect with PLC、DCS、FCS and computer for data

  collections. Contact encoders are available without working voltage,If neeeds,plwase indicate when ordering.

You should indicate when ordering if coupling needed to use with.Do not force directly when installing.Vibration on the rotary encoder usually

result in error pulse.therefore,much attention should be paid to sitting place and installing occasion.More pulse in every cycle,much more

narrow of the greof and much more susceptible to the vibration.When the encoder stops or rotate at low speed,the vibration on the shaft or bodymay results in shaking of the greof,and error pulse at last. Soft connector should be used when connecting coupling and the machine.