rf hardware setup empowering intelligent interaction qwizdom, inc.™ copyright 2007
TRANSCRIPT
RF Hardware SetupRF Hardware Setup
Empowering Intelligent InteractionEmpowering Intelligent Interaction
Qwizdom, Inc.™ Copyright 2007
Q4 RF or Q5 RF Student Remotes
1 Q5 RF Instructor Remote
1 RF Host
Charger
Multi-Charger (if applicable)
Screwdriver, Screws, Batteries (if applicable)
Software
Quick Reference Guide
Full User Guide on CDQwizdom, Inc.™ Copyright 2007
Qwizdom, Inc.™ Copyright 2007
Qwizdom, Inc.™ Copyright 2007
Qwizdom, Inc.™ Copyright 2007
The screwdriver is used to secure the screw in the back of the Q4 RF remote.
Screws are used to secure the Q4 RF remote battery cover.
Qwizdom, Inc.™ Copyright 2007
Single charger is for the Q5 RF Instructor remote.
Multi-charger comes with Q5 RF remotes.
“AA” batteries are for Q4 RF remotes.Qwizdom, Inc.™ Copyright 2007
Software depends on what is ordered.
Qwizdom Interact Qwizdom Actionpoint
Qwizdom, Inc.™ Copyright 2007
Plug the USB Cable into the RF Host.
Then plug the other end of the USB Cable into an open USB Port on your computer.
Qwizdom, Inc.™ Copyright 2007
When the RF Host is plugged in, you should receive a ‘New
Hardware Found’ prompt in the bottom right of the window.
Qwizdom, Inc.™ Copyright 2007
Click on the ‘New Hardware Found’ prompt.
The New Hardware wizard appears.
Qwizdom, Inc.™ Copyright 2007
The USB Drivers for the RF Host needs to be installed.
The USB Drivers are located on the Qwizdom software CD.
Qwizdom, Inc.™ Copyright 2007
Remove the software from the remote set pouch.
Place the CD into the CD-ROM drive.Qwizdom, Inc.™ Copyright 2007
Since there are two USB Drivers that need to be
installed for the RF Host, you will need to go through the
installation steps twice.
Qwizdom, Inc.™ Copyright 2007
Click on ‘No, not this time’ and click on Next.
Qwizdom, Inc.™ Copyright 2007
Click on ‘Install from a list or specific location (Advanced)’ and click on Next.
Qwizdom, Inc.™ Copyright 2007
Check ‘Include this location in search’ and click on Browse.
Qwizdom, Inc.™ Copyright 2007
Select the USB Drivers folder located on the Qwizdom Interact CD.
Then click on OK.
Qwizdom, Inc.™ Copyright 2007
Click on Next.
Qwizdom, Inc.™ Copyright 2007
The USB drivers will install.
Qwizdom, Inc.™ Copyright 2007
Click on Finish.
Qwizdom, Inc.™ Copyright 2007
The first USB Driver has been installed.
Repeat the steps to install the second USB Driver.
Qwizdom, Inc.™ Copyright 2007
Thank you for choosing Thank you for choosing Qwizdom!Qwizdom!
Cleveland Office 1-877-794-9366Seattle Office 1-800-347-3050
Tech Support: [email protected], Inc.™ Copyright 2007