r magic wands...magic wands portable shrink packaging system your best choice for all your wrapping...
TRANSCRIPT
SU
PER
MA
RK
ET
EQ
UIP
MEN
T
PACKAGING SYSTEMS
MAGIC WANDSPORTABLE SHRINK
PACKAGING SYSTEM
YOUR BEST CHOICE FOR ALL YOUR WRAPPING NEEDS
R
Features of the Magic Wand
Standard 115 Volt Power Supply
Fully Portable
Sealing Wand With Power Pack
Neoprene And Silicone Sealing Pads
Film Dispenser With Separator Bar
Hole Punch
Service Kit
Power Requirement:
Wattage:
Working Height:
Weight:
Constant Heat: (3.17 kg)
Impulse Heat: (6.35 kg)
Manual Impulse Heat:
Warranty:
115 Volt, 10 Amps, 60 Cycles
Single Phase Circuit With Ground
1,150 Watts
Table Top
(Wand and Power Pack Only)
7 lbs.
14 lbs.
9 lbs.
Ninety Days On Parts
(4.08 kg)
Model MWS-C-24” Long Seal Bar Table Top System
Specifications and Options
Crafted with pride in the
PMMI
R
MEMBER
Model MWSBT-C-24 With Optional AdjustableLegs, Casters and Label Dispenser
Options:
220 Volt Power Supply
HG-966 Hot Air Gun
HG-115V Hot Air Gun
HG-302A 220 Volt Heavy
Duty Master Hot Air Gun
24” Sealing Block
MW Alum. Tables In 2 Sizes
28” D, 44” W, 29” H
43” D , 29” H
Adj. Height Legs For Table
29” To 38” Overall Height
, 44” W
UL®C
Listed
Available Magic Wand SystemsM
AG
ICW
AN
DP
OR
TA
BLE
WR
AP
PER
R
For Additional Product Information, Contact:
HEAT SEALING EQUIPMENT LLC4580 EAST 71ST STREET CLEVELAND, OHIO 44125
(216)341 2022 (800)342 6329 FAX (216)341 2163
WEBSITE www.heatsealco.com E-MAIL [email protected]
Model MWS-M: Manual Impulse Heat
The same system as the except the
operator controls the length of the heating cycle
by depressing and holding the button switch. The
unit is not automatically cycled off but begins the
cool down cycle as soon as the button is released.
Available sizes:
MWS-I
18”, 24”
Model MWS-I: Timed Impulse Heat
The sealing wire is activated by a push button
switch which heats the wire to cut and seal the
film being used. The heating cycle is determined
by adjusting the seal timer on the power pack.
Following one complete cycle, the sealing wire will
cool until triggered again.
This unit provides for greater sealing consistency
as the timer controls the exact heat to the sealing
wire during every heating cycle.
Available sizes: 18”, 24”, 36”
Model MWS-C: Constant Heat
The sealing wire remains heated as long as the
unit remains on. The wire is protected by an
aluminum guard to protect the operator. The user
must press down on the spring loaded sealing
arm in order to cut and seal the film being used.
Available sizes: 18”, 24”, 36”