problem 1
DESCRIPTION
Material selectionTRANSCRIPT
7/17/2019 Problem 1
http://slidepdf.com/reader/full/problem-1-569116788bac7 1/1
The frst part o this experiment involved varying the rater angle when abricating
the test specimens The 4 test specimens were printed with a rater angle o 0°, 15°,
30° and 45° !"bse#"ently, the parts were s"b$ect to a tensile test
%o"ng&s 'od"l"s (')a* +ltimate tensile !trength
(')a*
iterat"re 3500-0 .egrees 0/455 1411/15 .egrees 0//02 15/342330 .egrees 0/15 1/0045 .egrees 015 1353
"r calc"lated %o"ng&s 'od"l"s was o"nd to be on the order o 0/ ')a with a max
o 0/4 ')a and a min o 01 This is smaller than 4 orders o magnit"de less than
the val"e o ) o"nd in literat"re which is 3,500 ')a The man"act"ring process
clearly has a signifcant impact on the strength o the fnal parts prod"ced
0 001 00/ 003 004 005 00 00
0
1
/
3
4
5
6aster 45 deg
6aster 30 deg
6aster 15 deg
6aster 0 deg
!train (mm7mm*
!tress (')a*
Figure 1 Stress vs. Strain for Varied Raster Angle
- http877wwwma9eitromcom7material:properties7)olylactic:cid:):)olylactide7