presentation1
DESCRIPTION
TRANSCRIPT
BY: CAMERON MACLAUGHLIN
BUILDING A GUITAR
The 4 main parts of the guitar
The body The neck
The headstock The fret board
Tools
Band saw
Belt sander
Router
Fretting tools
Chisel set
Drill press
Clamps
Materials
2”x16” hardwood board
2”x6” hardwood board template
Guitar hardwareWood glue Wood for the fret board
First set of steps
The body
Take the body board and trace the template on it.
Use the band saw and cut the board around where you traced.
Use the belt sander around the edges to sand off any cut marks.
Trace the holes from the template on the front and back of the guitar.
Use the router and cut the holes in the top and bottom of the guitar.
Second set of steps
The neck
Trace the guitar neck on the neck board.
Cut it out with the band saw.
Use the chisel set to round the back of the neck.
Drill the holes for the tuning pegs.
Third set of steps
The fret board
Trace the template of the fret board on the wood for the fret board.
Cut it out with the band saw.
Clamp the fret board to the neck and wait until dried.
Use the fretting tools to cut the slots for the frets. Then install the frets.
Forth set of steps
Full Assembly
Screw the neck into the body.
Install all the body hardware and neck hardware.
The Outcome