ppc 1 5-8 install inst
TRANSCRIPT
6176 East Molloy Road • East Syracuse, NY 13057-0278 • Tel: 315-431-7200 • Fax: 315-431-7201 • E-mail:[email protected] • www.ppc-online.com
Innovate. Connect.
Installation Instructions
C. Attach coring tool & stripping
tool to drill
Compression connectors for AVA7-50, AL7-50, LDF7, LCF 158, LCF 158 JA, & VXL7
KIT-HCG-1-5/8 PPC Tool Kit
CC-DF-A7
CC-DF-L7
CC-DF-JA7
SP-158 Prep/Strip Tool
Step #1
Step #2
With a few simple steps, PPC compression connectors can be easily and consistently installed on 1-5/8” cable
Safety Glasses
Always wear
safety glasses
when operating
tool
Hack Saw
1-5/8” Frame Set
HCG Tool
A. Straighten cable and position
hacksaw in valley of corrugation
and cut off the cable square.
B. Insert correct center
conductor pin into coring tool
and fi rmly tighten.
NOTE: – if using VXL cable use
“VXL” pin
C. Blade lever will rest fl at when
cut is complete
A. Remove the jacket until
outer conductor hits fi xed stop.
Be sure the cutting blade is
positioned over the valley of the
corrugation. Use the ball detents
as guide.
B. Release blade lever and
operate drill clockwise and
counter clockwise to cut
through inner and outer
conductor
D. Set drill speed to LOW
D. Remove coring tool.
REV 8.0
Port Seal
6176 East Molloy Road • East Syracuse, NY 13057-0278 • Tel: 315-431-7200 • Fax: 315-431-7201 • E-mail:[email protected] • www.ppc-online.com
Innovate. Connect.
Installation Instructions
Step #3
D. Core cable to remove
dielectric until outer conductor
reaches stop on coring tool.
A. Remove cable piece from
the side of the stripping tool.
Remove cable from tool.
B. Properly stripped and cut
cable is ready for dielectric
removal.
Step #4
C. Push connector onto cable
until it reaches the mark on the
cable.
A. Cable is properly cored B. Align outer conductor with
top edge of knurl on back piece
and mark cable in line with end
of connector.
Step #5
C. When fully compressed,
connector back will move away
from alignment mark.
A. Pull or push back the insert to
allow connector/cable to lay fl at
in frame.
B. Make sure connector is fully
seated in frameset (lying fl at).
Press tool trigger to compress
the connector. Do not push on tool/cable during compression.
C. Set drill speed to HIGH
REV 8.0
D. Add port seal to connector
to ensure a moisture proof
connection. The port seal should
sit in the fl at area behind the
threads.
THIS STEP IS REQUIRED TO PROTECT PRODUCT WARRANTY
Compression connectors for AVA7-50, AL7-50, LDF7, LCF 158, LCF 158 JA, & VXL7