Jamieson’s PowerTrac™ gates are a premier line of aluminum box-frame cantilever sliding

gates. Our proprietary truck assemblies and enclosed track system allow gates to span large

openings with ease. Gates are fully welded in quality controlled conditions. After fabrication

gates are separated into halves to meet shipping constraints. Filler materials are factory

installed with splicing provisions and hardware for manual operation. Re-assembly and

installation is provided. Specific wind-load certifications are provided.

POWERTRAC™ BOX GATES

800.527.6464

JAMIESON FENCE SUPPLY TECHNICAL SALES DEPARTMENT PHONE: 888-286-3362 FAX: 281-879-5558 WWW.JAMIESONFENCE.COM

TECHNICAL SERVICES

2 of 2 AMERICA’S MOST TRUSTED NAME IN FENCE SUPPLIES™

SMOOTH AND RELIABLE OPERATIONEach PowerTrac™ gate includes a minimum of (4) 10 in. heavy-duty truck assemblies. Each truck assembly encompasses (8) cylindrical bearing wheels rated at a 5,400 lb. static load each. The entire truck assembly has been tested and certified for a 7,500 lb. peak load. Two TrusTrac™ extrusions provide the cantilevering support and rigidity required for large gate openings. Geometry and section widths on our track are specifically designed for increased strength and rigidity to resist deflection over long spans and in high wind-load conditions. Each 6061-T6 aluminum track extrusion weighs 4.8 lb./ft by itself and over 6.5 lb./ft in conjunction with the top horizontal member.

SOLID CONSTRUCTIONPowerTrac™ gate frames are constructed from durable 6063-T52 structural aluminum to provide maximum life, durability and rust resistance. Each gate is custom fabricated to achieve superior squareness, balance and rigidity. All bay widths are ≤ 6 ft wide, equidistant and braced with (4) welded solid gusset plates. A minimum of (3) cross-braces per Primary Vertical Member and alternating diagonal cross-braces top and bottom span the length of the gate to join the front and rear panels as a rigid, single-piece box frame. Heavy wall vertical members, horizontal bracing and a second vertical support member are standard on each end for greater impact resistance, chain link tension (if applicable) and internal mounting of brackets or drive rail to eliminate protrusions from the end of the gate. Jamieson only uses stainless steel cable in our truss cable assemblies to eliminate stretching and re-adjustments that are more likely with other materials. These truss assemblies are oriented for adjustment in each direction, in each bay and on both front and back panels for adjustability throughout the entire gate length. Filler materials extend through the tail section of each gate for safety and symmetry. Thus, each gate can open to either side- eliminating the need to specify opening direction. Jamieson provides a complete line of gate hardware and accessories. Our manufacturing operations are certified to AWS D1.1/D1.1M and D1.2/D1.2M and provides the technological sand manufacturing expertise for custom applications.

Submittal drawings provided by Jaminson. Job Specificdrawings available on request.

YOUR CHOICE OF FINISH AND FILLER MATERIALSPowerTrac™ Box Gates are designed and manufactured to meet your standard or unique aesthetic requirements. Our engineering team and custom fabrication shop can provide design support, develop 3-part specs and manufacture the gate to meet your requirements. Mill finish aluminum and powder coated finishes are available.

OUR COMMITMENT TO YOUR SAFETYJamieson follows the standards developed by Underwriter’s Laboratory (U.L. 325) and ASTM F2200 as developed by ASTM International for all PowerTrac™ gates, regardless of manual or automated applications.

WARRANTYJamieson provides a 3-year limited warranty on PowerTrac™ Box Gates.

POWERTRAC™ BOX GATES