powered lawn mowers safety checklist...powered lawn mowers – safety checklist . general...

3
Powered Lawn Mowers Safety Checklist General Requirements Yes No N/A Comments 1. Are all power-driven chains, belts, and gears positioned or otherwise guarded to prevent contact during starting, mounting, and operation? 2. Is a shutoff device provided to stop operation of a motor or engine? (Note: This device must require manual reactivation to restart the motor or engine.) 3. Are all positions of the operating controls clearly identified? 4. Are the words “Caution: Be sure the operation control(s) is in neutral before starting the engine” or similar wording clearly visible at an engine-starting control point on self-propelled mowers? 5. For walk-behind and riding rotary mowers, is the mower blade enclosed (except on the bottom) and the enclosure extended to or below the lowest cutting point of the blade in the lowest blade position? 6. If guards must be removed to install a catcher assembly, is a warning affixed to the mower near the opening stating that the mower must not be used without either the catcher assembly or the guard in place? 7. Are openings in the blade enclosure that are intended for discharge of grass limited to a maximum vertical angle of the 30-degree opening measured from the lowest blade position? 8. Is the word “Caution” or stronger wording placed on the mower at or near the discharge opening? 9. After declutching or shutting off the power, do the blades stop rotating from the manufacturer’s maximum speed within 15 seconds?

Upload: others

Post on 15-Feb-2021

8 views

Category:

Documents


0 download

TRANSCRIPT

  • Powered Lawn Mowers – Safety Checklist

    General Requirements Yes No N/A Comments

    1. Are all power-driven chains, belts, and gearspositioned or otherwise guarded to preventcontact during starting, mounting, andoperation?

    2. Is a shutoff device provided to stop operationof a motor or engine?(Note: This device must require manualreactivation to restart the motor or engine.)

    3. Are all positions of the operating controlsclearly identified?

    4. Are the words “Caution: Be sure the operationcontrol(s) is in neutral before starting the engine” or similar wording clearly visible at an engine-starting control point on self-propelled mowers?

    5. For walk-behind and riding rotary mowers, isthe mower blade enclosed(except on the bottom) and the enclosureextended to or below the lowest cutting pointof the blade in the lowest blade position?

    6. If guards must be removed to install a catcherassembly, is a warning affixed to the mowernear the opening stating that the mower mustnot be used without either the catcherassembly or the guard in place?

    7. Are openings in the blade enclosure that areintended for discharge of grass limited to amaximum vertical angle of the 30-degreeopening measured from the lowest bladeposition?

    8. Is the word “Caution” or stronger wordingplaced on the mower at or near the dischargeopening?

    9. After declutching or shutting off the power, dothe blades stop rotating from themanufacturer’s maximum speed within 15seconds?

  • Walk-Behind Rotary Mowers Yes No N/A Comments

    10. Is the horizontal angle of the opening(s) inthe blade enclosure intended for the dischargeof grass directed so it does not contact theoperator?

    11. Is the highest point on the blade enclosurefront (except discharge openings) 1 ¼ inchesor less above the lowest cutting point of theblade in the lowest blade position?

    12. Is the mower handle fastened to the mowerto prevent loss of control by uncoupling?

    13. Is a positive up stop or latch provided for themower handle in the normal operatingposition? (Note: The up stop shall not bedisengaged during normal operation of themower.)

    14. Do wheel-drive disengaging controls (exceptdeadman controls) move opposite to thedirection of the vehicle motion to disengagethe drive? (Note: Deadman controls shallautomatically interrupt the power to a drivewhen the operator’s activating force isremoved and may operate in any direction todisengage the drive.)

    Riding Rotary Mowers

    15. Are openings placed so that grass or debriswill not discharge directly toward any part ofthe operator’s seat in the normal operatingposition?

    16. Is one of the following present at allopenings in the blade enclosures intended forgrass discharge?

    (a) A minimum unobstructed horizontaldistance of 6 inches from the end of thedischarge chute to the blade tip circle;(b) Are vehicle stopping means provided?

    17. Are mowers provided with stops to preventjackknifing or locking of the steeringmechanisms?

  • 18. Do hand-operated wheel-drive disengagingcontrols move opposite to the direction of thevehicle motion to disengage the drive?

    19. Do foot-operated, wheel-drive disengagingcontrols disengage the drive when depressed?

    20. Do deadman controls (both hand and foot-operated) automatically interrupt the power tothe drive when the mower’s actuating force isremoved and operate in any direction todisengage the drive?

    KEMI does not assume liability for the content of information contained herein. Safety and health remain your responsibility. This information is to be used for informational purposes only and not intended to be exhaustive or a substitute for proper training, supervision or manufacturers’ instructions/recommendations. KEMI, by publication of this information, does not assume liability for damage or injury arising from reliance upon it. Compliance with this information is not a guarantee or warranty that you will be in conformity with any laws or regulations nor does it ensure the absolute safety of any person, place or object, including, but not limited to, you, your occupation, employees, customers or place of business.

    1 Are all powerdriven chains belts and gears: 2 Is a shutoff device provided to stop operation: 3 Are all positions of the operating controls: 4 Are the words Caution Be sure the operation controls is in neutral before staring the engine or similar wording clearly visible at an enginestarting control point on selfpropelled mowers: 5 For walkbehind and riding rotary mowers is the mower blade enclosed except on the bottom and the enclosure extended to or below the lowest cutting point of the blade in the lowest blade position: 6 If guards must be removed to install a catcher assembly is a warning affixed to the mower near the opening stating that the mower must not be used without either the catcher assembly or the guard in place: 7 Are openings in the blade enclosure that are intended for discharge of grass limited to a maximum vertical angle of the 30degree opening measured from the lowest blade position: placed on the mower at or near the discharge: 9 After declutching or shutting off the power do: the blade enclosure intended for the discharge: front except discharge openings 1 ¼ inches: 12 Is the mower handle fastened to the mower: 13 Is a positive up stop or latch provided for the mower handle in the normal operating position Note The up stop shall not be disengaged during normal operation of the mower: 14 Do wheeldrive disengaging controls except deadman controls move opposite to the direction of the vehicle motion to disengage the drive Note Deadman controls shall automatically interrupt the power to a drive when the operators activating force is removed and may operate in any direction to disengage the drive: 15 Are openings placed so that grass or debris: 16 Is one of the following present at all openings in the blade enclosures intended for grass discharge a A minimum unobstructed horizontal distance of 6 inches from the end of the discharge chute to the blade tip circle b Are vehicle stopping means provided: 17 Are mowers provided with stops to prevent: 18 Do handoperated wheeldrive disengaging: controls disengage the drive when depressed: 20 Do deadman controls both hand and foot operated automatically interrupt the power to the drive when the mowers actuating force is removed and operate in any direction to disengage the drive: Group3: OffGroup4: OffGroup5: OffGroup6: OffGroup7: OffGroup8: OffGroup9: OffGroup10: OffGroup11: OffGroup1: OffGroup2: Off1: Off2: Off3: Off4: Off5: Off6: Off7: Off8: Off9: Off