pool volleyball system
TRANSCRIPT
POOL VOLLEYBALL SYSTEMINSTRUCTIONS
UNITED VOLLEYBALL SUPPLY, LLC. 14615 NE 91ST ST, BLDG B, REDMOND,
WA 98052 • 1996-2007© VOLLEYBALLUSA.COM
PH: 1-800-494-3933FAX: 425-827-2230
Parts List
Attach (2) carbiner clips to one pole and (2) rope ratchets to the pole intended for the opposite side of the pool. *This hardware may arrive already pre-attached.
Once hardware is on each pole, insert each pool pole into the installed ground sleeves.
Tie a loop knot for the top and bottom lines of one side of your pool volleyball net, allowing you to attach each rope to the carabiner clips of your pool volleyball pole.
On the other side, feed the top and bottom lines through the rope ratchets.
Simply insert the rope as shown in the image above. You may need to “help” feed the rope through by using your thumb to rotate the gear within the ratchet (dashed line). Leave 1-2 inches of rope out the end of the ratchet until you are ready tighten the net.
To loosen, pull the rope and release the silver lever.
1
1
2
53
4
1
2
2
(2) Pool Vollyball Poles (1) Pool Volleyball Net (2) Rope Ratchet Clips (2) Carabiner Clips