MIG WELDER/PLASMA CUTTER CART 4 DRAWER CABINET

INSTRUCTIONS

Part #20181

© Copyright 2014 Easthill Group, Inc. Instruction part #20181Q Rev. 6/14

If you have any questions about the use of this product, please contact The Eastwood Technical Assistance Service Department: 800.544.5118 >> email: techelp@eastwood.com

PDF version of this manual is available online >> eastwood.com/20181manual

The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA US and Canada: 800.345.1178 Outside US: 610.718.8335

Fax: 610.323.6268 eastwood.com

The Eastwood 4 Drawer Welding Cart Cabinet is constructed of heavy-gauge, powder-coated steel to provide years of rugged and reliable service. It is designed to fit the Eastwood #20232 MIG Welder/Plasma Cutter Cart and features lockable, telescoping glide drawers.

INCLUDES (1) 4 Drawer, Lockable Cabinet (1) Mid-Shelf Panel (2) 6mm Bolts & Washers (2) Keys NOTE: The Mid-Shelf Panel, Hardware and Keys are shipped in the top drawer.

REQUIRED TOOLS• 10mm wrench

ASSEMBLYNOTE: The Mid Shelf Panel is designed to replace the Center Shelf (F) of the Eastwood #20232 MIG Welder/Plasma Cutter Cart. This shelf along with the Lower Shelf Edge may be discarded. (Please retain 4 sets of 6mm Bolts, Washers & Nuts.)

INSTALLING MID-SHELF TO REAR PANEL AND THE REAR OF 4 DRAWER CABINET:NOTE: The four edges of the Mid-Shelf (F) have bent flanges. Install Mid-Shelf with flanges facing upward.

1. Align the Mid-Shelf’s two long-flange holes with two holes in the upper rear panel of the 4 Drawer Cabinet. Apply washers to two 6mm Bolts and thread into the rear of 4 Drawer Cabinet.2. Tighten bolts only “finger-tight” to allow for alignment in following steps.3. Align the Mid-Shelf’s two end-flange holes with the two holes in the Rear Vertical Panel, (E) of the Eastwood #20232 MIG Welder/Plasma Cutter Cart. Place two 6mm Bolts through holes and apply Washers & Nuts.4. Tighten all hardware.

E

F

��✓�����

��✓�����