one-point localization
DESCRIPTION
One-Point Localization. Setting Up a One-Point Localization. 1. Tap the Data menu tab. 2. Tap Project. 3. Tap the current open project (in this case, Concord Training ). 4. Tap New. 5. Tap the box underneath New project file name. - PowerPoint PPT PresentationTRANSCRIPT
One-Point LocalizationOne-Point Localization
Setting Up a One-Point Localization
1. Tap the Data menu tab.
2. Tap Project.
3. Tap the current open project (in this case, Concord Training).
4. Tap New.
5. Tap the box underneath New project file name.
6. Type in the desired project name (in this case, ONEPOINT) and then tap Ok.
7. Tap Ok once satisfied with the project file name.
8. Highlight the new project file and tap Ok.
9. Tap Yes to confirm the project you wish to open.
10. Tap the Data menu tab.
11. Tap Control.
12. Tap Control points.
13. Tap Add.
14. Tap the empty box beside Name.
15. Type in the desired control point name (this will be the point on which your base will be set) and then tap Ok.
16. In order to add a description to your control point, tap the drop down arrow below Description.
17. Tap new description.
18. Type in your desired description and then tap Ok.
19. Type in desired North, East, and Elevation coordinates using their respective blank boxes. These numbers are arbitrary. Tap Ok
when finished.
20. Tap Ok when finished.
21. Tap the Setup menu tab.
22. Tap Base Station.
23. Choose the desired Control point (which should be the newly created Base point) and Connection type (this will be COM8 if
using Bluetooth) and then tap Next.
24. Choose the desired Antenna type (type of receiver being used), Antenna height (distance between the height of the control point and the
receiver), and Measured to (Base or Rim) settings. Tap Next when finished.
25. Double-check the desired Radio type, Port, Baud rate, and Format. These should not have changed from previous equipment
settings.
26. Double-check GPS receiver settings and then tap finish. You can then connect to the Base and Rover receivers as previously discussed. See the presentation Base Set-Up for more details.
27. Once you are connected to both your Base and Rover receivers, tap the Data menu tab.
28. Tap Control.
29. Tap Control points.
30. Highlight your Base control point and tap Edit.
31. Tap the GPS tab.
32. Check the Use horizontal and Use vertical options. Tap Ok when finished.
33. Tap Ok when finished.
All data will be relative to the Base coordinates and elevation. It is suggested that you set some additional control points and measure them in as Control Points Without Known Coordinates. This will create a check, as well as
a back-up in case your original control point is destroyed. See the presentation Localization for more details.
One-Point LocalizationOne-Point Localization