Nature2 Quick-Start Guide1. Clean Tub & New or Clean Filter(s)

Fill spa with fresh water. After full, jets must be on to circulate the water while adding chemicals to effectively distribute throughout entire tub.

2. Fill spa and circulate water with jets

3. Test water

5. Add Metal Free

4. Add natural clarifier

Start with an empty, clean tub and new or clean filter cartridge(s). (Use Spa System Flush when transitioning from any previous sanitizer system.)

Total Alkalinity (TA): 80 - 120 ppm pH: 7.2 - 7.6

10. Place ZorbO in spa

Test water with MPS 3-Way Test Strips and Hardness Test Strips; adjust where necessary.

Add 1 oz. of natural clarifier per 500 gallons of spa water, weekly.

Add Metal Free stain/metal preventer per label instructions.

Allow water to circulate to equilibrate spa chemicals for an hour or two (or overnight) then retest; adjust if necessary.

Place and keep ZorbO in spa to absorb oil scum.Rinse out every 1 - 2 weeks and replace every 3 - 6 months.After each spa use, add 1 - 2 tablespoons Oxy-Spa. (800) 823-3638

Mon-Fri 6 AM - 5 PM PST

Total HardnesspH

MONOPERSULFATE (MPS)

TOTAL ALKALNITY

MPS3-in1

Test Strips

Calcium Hardness: 150 - 300 ppm

7. Circulate water for 1 - 2 hours and retest

Total HardnesspH

MONOPERSULFATE (MPS)

TOTAL ALKALNITY

MPS3-in1

Test Strips

8. Assemble Nature2

Remove Nature2 for Spas from package and follow filter style installation instructions to determine which stems are needed.

Nature2

9. Add Nature2 to filter, replace in spaShut spa off and remove filter. Place Nature2 cartridge as directed. Once installed, Nature2 must be at least 1” above the bottom of the filter to assure proper water flow and prevent blockage. Replace filter back in spa and turn power on.

N2

N2

N2 N2

StandPipe

N2

N2

N2 N2

StandPipe

Open Center - CORRECT install

Open Center - WRONG install

Open Center - with Stand Pipe

Closed Top - Correct Install

Nature2 Filter Style Installations

Follow label instructions according to your spa’s capacity guidelines.

Pro Supplies Kit #KT1005

6. Add Dichlor/Stabilizer

Add Dichlor Stabilizing granules to activate Nature2 cartridge. At startup, add 2 tablespoons per 500 gallons.