Nadine  Anseeuw    

Noel  Bacani  

Project  Goals  

General  Knowledge  of  SW  

Complex  Surfacing  

FEA  with  Solidworks  and  Pro/E  

Sustainability  Reports  

Rendering  Techniques  

About  the  Cycloc  

§   Practical  bike  storage  for  your  home  

§ Capable  of  holding  most  bicycles  

§ Very  stylish  design  –  no  sharp  edges  § Made  with  recycled  products  and  is  considered  a  sustainable  

Choosing  the  Software  

• Chose  SolidWorks  • Handles  Complex  Surfaces  

• Designer  of  Cycloc  used  Solidworks  

• No  prior  experience  with  SW  

• Easy  to  use  

Modeling  

Curve  of  the  Body  

Tapered  Lip  

Helical  Sweep  Cut  

Fillets  

Curve  of  Main  Body  

Tapered  Lip  

Helical  Sweep  

Fillets  

FEA  Objectives  

§ Compare  SW  and  Pro/E  results  § Optimize  the  design  § Factor  of  Safety  

SolidWorks   Pro/E  

Max  Displacement  =  2.677e-­‐2  mm   Max  Displacement  =  3.306e-­‐2  mm  

Simulation  Express  Optimization  

§ Min  =  8.1mm,  Max  =  35mm  § Constraint:  Min  16.5  for  Factor  of  Safety    § Minimize  Mass  

ManualOptimization  Design   Tip  

Thickness  (mm)  

Weight  (grams)  

Max  von  Mises  Stress  (N/m2)  

Max  Displacement  (mm)  

Min  Factor  of  Safety    

Option  1   15   5873.76   243,287.5   0.2511   28.34  

Option  2   10   5238.13   246,244.2   0.2567   28.0  

Option  3   8   5212.32   248,254.3   0.2562   27.77  

Option  4   7   5197.08   254,951.8   0.2552   27.00  

Option  5   6   5183.16     228,608.3   0.2537   30.16  

SolidWorks  

PhotoView  360  

PhotoView  360  

PhotoView  360  

Thank  You  Very  Much!  

Questions?  

Go  Canucks  Go!