ns.

The MV160 delivers a seamless combination of carrier-grade TDM (Time Division Multiplexing) and Ethernet packet data at full duplex rates of 160Mbps. Unlike other solutions using TDM over IP conversion systems, the MV160 uses native TDM framing. This delivers unparalleled TDM signal and frame timing accuracy to meet all carrier-grade requirements.

The system can be managed via web-based GUI, SNMP, or serial-based command line interface programmability is built into the solution and the user can easily program parameters such as bandwidth, modulation and data rates. Additional features such as FEC will insure the quality of the link condition for mission critical applications.

ory standards.

MV160 Digital Microwave Radio50 to 160Mbps from 8 to 38GHz2 x 100BaseT + 4E1

Product Features

Cost effective, high-capacity system for transport • of native TDM and IP traf�c

Data throughput: up to 320Mbps • (160Mbps Full Duplex) with up to 4x E1 (Integrated)

Proprietary implementation of native, transparent • TDM transport across the wireless link

Flexible modem con�guration•

- Programmable bandwidths and symbol rates

- Programmable modulation modes (QSPK to 128 QAM)

- Programmable FEC

Split architecture for maximum �exibility in • frequency selection and system reliability

MV160 Product Range

Enhanced Ethernet traf�c management •

- VLAN-based link management

- Port-based QoS Priority assignment

- Port-based data rate limiting

Link management interface•

-Web-based link management

-SNMP monitoring

-RS-232 Command line interface (Telnet and SSH)

Field upgradable �rmware•

Single cable interface to the ODU for data and • power

1U 19-inch rack mount IDU•

Wireless Tech (Australia) Pty Ltd | www.wirelesstech.com.au | sales@wirelesstech.com.au | +61 2 8741 5080

MV160

Frequency 8GHz 11GHz 18GHz 23GHz 38GHzFrequency Band (GHz) 7.9-8.5 10.7-11.7 17.7-19-7 21.2-23.6 37.0-40.0T-R Spacing (MHz) 208,311 490,530 1010,1560 1008,1232 700,1260

SystemFrequency Bands 8-38GHzModulation Mode QSPK, 16QAM, 32QAM, 64QAM, 128QAM

Channel BandwidthCEPT/ETSI 7, 14, and 28MHzANSI/FCC 10, 20, and 30MHzData Rate Options 50, 100 or 160MbpsRF Output Power up to 30 dBm

RX Sensitivity at BER= 10-6

QPSK -73 dBmQAM16 -69 dBmQAM32 -67 dBmQAM64 -65 dBm

QAM128 -62 dBm

IF Frequencies 350 MHz (Tx) and 140 MHz (Rx)Forward Error Correction

End-to-End Latency Less than 250 microsecondsLink Quality Metrics ITU-T G.826 supportPower Supply -20 to -60 VDC to IDU (ODU powered by IF Cable) Power Consumption 60W, typicalMTBF 32 yearsCompliance FCC part 101, ETSI EN 302 217-2-2 (ODU)

Outdoor Unit (ODU)

Size 26.7cm in diameter 8.9cm in heightWeight 4.6kgTemperature -33 C to 55 C

Indoor Unit (1DU)

Size (HxDxW) 4.3 x 35.6 x 43.2cmWeight 4.1kgTemperature -0 C to 40 C

InterfaceIDU Data Interface (4) 100 Base-T and up to 16T1/E1IDU/ODU Interface (2) N-type connector (female)IF Cable (2) 50 Ohm coax cableLEDs Power, Alarm, FaultEthernet SNMP, Web ManagementRS232 Command Line Interface

Wireless Tech (Australia) Pty Ltd | www.wirelesstech.com.au | sales@wirelesstech.com.au | +61 2 8741 5080