mtm part setup calculator v1.2
DESCRIPTION
GibbsCAMTRANSCRIPT
7/17/2019 MTM Part Setup Calculator v1.2
http://slidepdf.com/reader/full/mtm-part-setup-calculator-v12 1/1
1 31mm
30mm
7mm
12mm
79mm
4mm
90mm
52mm
0.0000
4.0000
0.1500
0.1500
0.3170
0.4250
1.5000
4.3000
5.0420
4.6170
2.6500
• What is the distance ofthe part face from Z0?(pos. or neg. # is okay)
• What is the length ofthe part geometry? See A
• What is the facingallowance on Spindle 1?See B
• What is the facingallowance for Spindle 2?See C
• What is the width of the
cut off? See D
• What is the cut offclearance? See E
• How far on the partdoes the sub Spindlegrip (what is the Grip Zvalue)? Enter a positivenumber. See F
Total length of the stock(see G):
Part face distance fromspindle face (see H):
Distance to feed the stockon reload:
Amount part sticks out ofSub Spindle (see I):
Spindle 1
Stock in Chuck
Spindle 2
Workspace
Rendered Part
B
A
C
D
E
F
H
G
I
Geometry
Results
This image represents a part. The sub spindle isgripping the part and a cut off has been done. The subspindle has not yet returned. You can see the partiallycut part, the geometry, workspace and stock in thechuck as well as the spindles.