mt-card 3ds v1.3 firmware upgrade to support eshop, solve memory card problem
TRANSCRIPT
MT Card Professional & Official Resller
www.4CoolDay.com
USB Ver1.3 Program Update Instruction
MT card Ver1.3 supports Eshop game “super mario bros.deluxe”,
and fixes the problem withlow speed Micro SD card which causes
animal crossing and pokemon X/Y games can not be played.
We need Ver1.2 “Launcher.dat ” to run Eshop games.
No matter which version you use, just directly update your MT card
to Ver1.3.
If you once updated MT card to Ver1.2 on your computer, and want
to update the card to Ver1.3, when you connect the MT card to the
computer, your computer will search and use the driver you
installed last time, no need to install driver again. For computer
without Ver1.2 program update, to update your MT card to Ver1.3,
you need to install driver. While updating, make sure the USB cable
is connected, don’t disconnect.
Www.4CoolDay.com
Download the USB Ver1.3 from
http://www.mt-card.com/download/MT_Card_Updater_1.3.rar
Notice: please make sure the USB is connected, don’t disconnect.
And make sure your computer is connected to the internet.
While updating, the computer will automatically install the driver
twice. If the driver has not been installed, you can open the
computer device manager, check other device, click unknown
device, right click the “Update Driver”, wait till installation finished.
Since computer system comes with driver, no need to provide
driver.
Www.4CoolDay.com – MT Card Official Reseller
1. Unzip the file, run the program file MT_Card_Updater v1.3.exe
Www.4CoolDay.com
2. Use a micro USB cable to connect MT card to the computer.
3. After connecting , the computer will automatically install the
drivce, and then shows you a picture as below, “update” is
available.
4. Click “update”, it will detect the driver installation of MT card.
Www.4CoolDay.com
5. If all OK, comfirm the update, click “Yes” to update.
6. Updating, start writing data to MT card.
Www.4CoolDay.com
7. When the first progress bar is finished, your computer indicates
Found New Hardware, click it
8. It will show an interface as below, wait till the FPGA update
finished, about 60seconds
Www.4CoolDay.com
9. Just wait
10. After installation, your computer will ask you to restart, click
“Restart Later”.
Www.4CoolDay.com
11. Back to the MT card update interface, the second progress bar
begins, start writing data to the FPGA chip, it will take longer time,
about 3 minutes
12. The third progress bar begins, writing data to CPU
www.4CoolDay.com USA MT-Card official Reseller
13. When the third progress bar is finished, it will show you update
success, you can disconnect the USB connecting
Www.4CoolDay.com
End…………………………………………………………………………
……………
A: If you got an error as below
Www.4CoolDay.com
It means the installation has not been finished in 300 seconds from
step 7
Open the computer device manager, check other devices, click
unknown device
Www.4CoolDay.com
When it is done, try to update the Ver1.3 program again, all will be
OK, step 7-step
10 will not appear, directly to step 11.
B: If you got error as below
Www.4CoolDay.com
Comfirm OK and rerun the update program according to the
instruction.
Buy MT-Card from Professional&Official Reseller
4CoolDay.com, stocks local in USA&Singapore, fast to worldwide.