Y787 折叠式吊卡SIZE:180X235MM（-0.5，+0MM）R:8MM

材质：双白卡 250G 过UV

Y787 high performance digital lock will protect luggage, bicycles and other personal belongings in home or store. When anyone cut the cable or remove the battery cover or key in wrong password or detected vibration or remove the belongings , the unit will activate high output piercing alarm.

● The interval time between two detected vibration or removing the lock over three seconds activates alarm● Cut cable or remove the battery cover activates alarm● Three times wrong code activates alarm● The steel cable can be used as self-defense whip● Alarm sound up to 105dB ● 80cm toughened steel cable ，diameter: 10mm (optional cable length: 1.2 meters、2 meters、3 meters）● Programmable 4 digital password,up to 256 kinds of passwords● Easy operation, no need keys● 3 x AAA size alkaline batteries operation(not included) and low battery indicator● IP44 rating approved● Operating use temperature: -10℃～+60℃

1. Cable2. Password key (1,2,3,4)3. / key4. Buzzer5. In-use/Battery low LED6. Lock bar7. Battery cover8. Battery waterproof silicone

Model:Y787Model:Y787

2

1

3

4

5

6 7

8

Y787 high performance digital lock will protect luggage, bicycles and other personal belongings in home or store. When anyone cut the cable or remove the battery cover or key in wrong password or detected vibration or remove the belongings , the unit will activate high output piercing alarm.

● The interval time between two detected vibration or removing the lock over three seconds activates alarm● Cut cable or remove the battery cover activates alarm● Three times wrong code activates alarm● The steel cable can be used as self-defense whip● Alarm sound up to 105dB● Operating use temperature: -10℃～+60℃

1.Cable2.Password key (1,2,3,4)3. / key4.Buzzer5. In-use/Battery low LED6. Lock bar7. Battery cover8. Battery waterproof silicone

* The unit alarm sound is very loud, never put the unit close to your ear.* The unit can provide valuable protection for your belongings,however do not guarantee complete protection against for any losses. Please take care of all your property.

1 2

43

4

2

3

6

1

5

AAA

AAA

AAA

AAA

AAA

AAA

（Fig 1）

（Fig 2）

（Fig 3）● 80cm toughened steel cable ，diameter:10mm (optional cable length: 1.2 meters、2 meters、3 meters）● Programmable 4 digital password,up to 256 kinds of passwords● Easy operation, no need keys● 3 x AAA size alkaline batteries operation(not included) and low battery indicator● IP44 rating approved

1. In order to reduce risks and losses, change new batteries immediately, when battery voltage is low. If you do not use the unit for a long time, please remove the battery to avoid battery leakage.2. The unit is waterproof, but it can’t be soaked in the water. In freezing weather ,please dry off the water near the lock bar in case the water freezes which may cause the lock bar get stuck.3. The product has no memory function. Remove the battery or blackout ,the password and setup will reset to initial factory setting(factory setting password ‘1234’,vibration detect function is on) Please reset the password as soon as possible.4. When lock or unlock, please operate it according to the tone, do not press the lock bar immediately.

* Internal Power supply:3x‘AAA’size alkaline batteries operation* Battery Life: Standby about 1 year* Cable specification: length:800mm;diameter:10mm* Working temperature: -10℃～+60℃* Storage temperature: -20℃～+80℃* Product weight: 228G* Size: 92X55X34mm

1 2

431 2

43

Hold down the button first

Then

pull o

ut ca

ble

7

8

C:0% M:100% Y:100% K:0%

C:0% M:0% Y:0% K:15%

C:100% M:0% Y:100% K:0%

Digital Lock With AlarmDigital Lock With AlarmDigital Lock With AlarmDigital Lock With Alarm

● Self-defense function:steel cable can be used as self-defense whip ● Alarm sound up to105 dB ● Easy operation, no need keys ● Waterproof, suitable for indoor and outdoor use ● Ability to work under sever temperature: -10℃～+60℃ ● Optional colour: steel gray or black

● Anti-cut function: cutting cable activates alarm immediately

● Tamper resistant function: removing the battery cover activates alarm● Anti-burglary function: three times wrong code activates alarm● Vibration function: vibration or removing the unit activates alarm

INTRODUCTION

FEATURES

DESCRIPTION OF COMPONENTS

INTRODUCTION

FEATURES

DESCRIPTION OF COMPONENTS

Model Y787 Owner’s ManualDigital Lock With Alarm

ELECTRICAL SPECIFICATION

IMPORTANT SAFETY TIPS

INSTALLATION1. Batteries installation a). Unscrew the battery cover to install three alkaline batteries,make sure install with correct polarity (Fig1), screw the battery cover. b). After the battery installation, the unit will sound ‘Bi Bi’, and the LED will flash 1 to 2 sec. c). Well screw the battery compartment before use.2. Main unit installation Press and hold the lock bar then pull out the cable (fig.2), fix on the belongings which you need to be protected.

OPERATION 1. Change the password. (Assure the user in safety, please change password when replace the new battery each time, factory setting password ‘1234’) a). Make sure the unit not in the LOCK mode. b). Press and hold the [1] button 2 seconds, unit will sound a ‘Bi’ tone and the LED will flash c). Key in the old password (factory setting password ‘1234’) ,the unit will sound ‘Bi Bi’tone. Please key in 4 digits new password (the password must be 4 digits), after the passwords input completed, the unit will sound ‘Bi Bi Bi’to remind the password change is successful.Note: Remove the battery or blackout ,the password and setup will reset to initial factory setting ‘1234’.If forget your password, please tack out the battery and press the / button for more than 5 seconds, the password and setup will reset to initial factory setting ‘1234’.2. Programmable Vibration Detect Function ON or OFF(The unit initially factory set vibration detect function ON.)a). Make sure the unit not in the LOCK mode.b). Press and hold [2] button 2 seconds will hear a‘Bi’tone,the vibration detect function set at OFFc). when press and hold [2] button 2 seconds again, will hear short ‘Bi Bi’, vibration detect function set at ON.

3. LOCK And UNLOCK LOCK: a). LOCK:Press [ / ] button once and do not push the lock bar. The unit will sound three‘Bi Bi Bi’, LED will flash every 3 seconds, then the unit is in the LOCK mode. b). UNLOCK: In the lock mode, enter your 4 digits password then press [ / ] button and do not push the lock bar . The unit will sound one long ‘Bi’tone, this sound reminds to exit lock mode ,LED will be off ,then you can press lock bar and pull out cable(Fig 3).

4. Alarm mode a). In the locked mode , when anybody cutting the cable ,the unit will trigger to alarm instantly Enter your password then press [ / ] button, the alarm will stop. b). In the locked mode, when anybody removing the battery cover, the unit will trigger to alarm instantly. Enter your password then press [ / ] button, the alarm will stop. c). In the locked mode, when key in wrong password, the unit will send one long ‘DU’ sound instantly. When you hear the ‘DU’ sound , must resume key in right password. If key in wrong password three times within 10 seconds, the unit will alarm for 30 seconds. d). In the locked and vibration mode, when the unit detected trigger for vibration or moving your belongings, the unit will first turn on alarm 1 second for warning. If the unit detected trigger again after the next three to twelve seconds, the unit will turn on alarm for 30 seconds; If do not trigger during three to twelve seconds, the unit will return to standby mode.

[LOW BATTERY DETECTION] When battery goes low, the LED will flash once per-second,please change to new alkaline batteries immediately, otherwise the unit can’t lock and unlock operation.

TROUBLE SHOOTING GUIDE

Trouble Reasons Solution

No alarm when triggered in the locked mode

1. Battery cover is not well screwed

2. The cable is not plugged in lock hole or not deep enough

3. Vibration detect function is off

1. Check if the battery cover is well screwed

2. Make sure the cable is plugged in lock hole and deep enough

3. Set off the vibration detect function when belongings are easily

moved by others

No vibration detect function

1. Vibration detect function is off

2. The strength of vibration is low

1. Check whether the vibration detect function is on

2. More than 0.6 kilogram impact force will cause the vibration

Can’t unlock

1. Wrong password

2. Low battery

3. Temperature is too low

4. Lock bar gets stuck

1. Check whether the password is right.

2.Check battery, when battery voltage is low, change new batteries, alkaline battery is suggested.3.Please put the unit between -10℃～+60℃. Low temperature may cause low battery voltage which leads to fault.4. Check whether the lock bar gets stuck

Can’t lock1. Low battery

2. Lock bar gets stuck

1. Check battery, when battery voltage is low, change new batteries, alkaline battery is suggested.2. Check whether the lock bar gets stuck

CAUTIONS

YEAR

WARRANTY11

BICYCLE ALARM

MOTORCYCLE ALARM

LAWN MOWERS ALARM

LUGGAGE ALARM

STORE DOOR ALARM

HOME DOOR ALARM

BICYCLE ALARM MOTORCYCLE ALARMLUGGAGE ALARM DOOR ALARM

SHENZHEN OYC ELECTRONICS Co.,LTD.TEL: +86-755-89914016FAX: +86-755-89550806

Website: http://shop1363803889756.cn.1688.com/E-mail:oyc_ws@163.com

Address: 3/F,NO.14 JiXiang South Road,LongCheng Street,LongGang District,ShenZhen City,China

Zip: 518172

SHENZHEN OYC ELECTRONICS Co.,LTD.TEL: +86-755-89914016FAX: +86-755-89550806

Website: http://shop1363803889756.cn.1688.com/E-mail:oyc_ws@163.com

Address: 3/F,NO.14 JiXiang South Road,LongCheng Street,LongGang District,ShenZhen City,China

Zip: 518172

Made in China

◆ Patented product,counterfeiting is not allowed. (Patent number:201320506211.3) ◆ Please check the reverse side of the blister card for detailed operation

Made in China