1 The license manager has been installed as a service on your machineBefore running MATLAB, you must manually start the license manager by using lmtools.exe (found in the etc folder of your installation folder), or by rebooting your machineFor more information see the Installation Guide for Windows2 The following products require a supported compiler: MATLAB Compiler 4.15 MATLAB Builder NE 4.0 MATLAB Builder JA 2.2.2 MATLAB Builder EX 2.0 Stateflow 7.7 Simulink Coder 8.0 xPC Target 5.0 MATLAB Coder 2.0 3 Simulink requires a C compiler for simulation acceleration, model reference, and MATLAB Function Block capabilitiesIt is recommended that you install a supported compiler on your machine4 To accelerate computations with the following products, a supported compiler is required: SimBiology 3.4 Fixed-Point Toolbox 3.3 5 After this installation is complete, you should continue with your configuration of the MATLAB Distributed Computing Server as outlined in the instructions obtained from www.mathworks.com/distconfig 6 You have installed xPC TargetUse the xPC Target Explorer GUI (type xpcexplr in the MATLAB Command Window) to correctly configure xPC Target with a valid compiler pathnameFor further help, type doc xpcexplr7 Run mbuild -setup from MATLAB before using MATLAB Compiler or builder products.http://in.mathworks.com/support/compilers/R2011a/win64.html?s_cid=pi_scl_2_R2011a_win64