macbook pro 13' unibody mid 2009 battery replacement · macbook pro 13" unibody: seven 3...
TRANSCRIPT
MacBook Pro 13" Unibody Mid 2009 BatteryReplacement
If your battery no longer holds a charge, use this guide to replace it.
Written By: Walter Galan
MacBook Pro 13" Unibody Mid 2009 Battery Replacement Draft: 2019-05-20Guide ID: 1332 -
This document was generated on 2019-09-16 01:34:16 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 5
INTRODUCTION
Use this guide to replace an old or faulty battery and revitalize your MacBook Pro. If your battery isswollen, take appropriate precautions.
TOOLS:Phillips #00 Screwdriver (1)Spudger (1)Tri-point Y0 Screwdriver (1)
PARTS:MacBook Pro 13" Unibody (Mid 2009 to
Mid 2012) Replacement Battery (1)
MacBook Pro 13" Unibody Mid 2009 Battery Replacement Draft: 2019-05-20Guide ID: 1332 -
This document was generated on 2019-09-16 01:34:16 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 5
Step 1 — Lower Case
Remove the following 10 screwssecuring the lower case to theMacBook Pro 13" Unibody:
Seven 3 mm Phillips screws.
Three 13.5 mm Phillips screws.
Step 2
Slightly lift the lower case and pushit toward the rear of the computer tofree the mounting tabs.
MacBook Pro 13" Unibody Mid 2009 Battery Replacement Draft: 2019-05-20Guide ID: 1332 -
This document was generated on 2019-09-16 01:34:16 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 5
Step 3 — Battery
Remove the following tri-pointscrews securing the battery to theupper case:
One 5.5 mm tri-point screw.
One 13.5 mm tri-point screw.
Step 4
Use the flat end of a spudger to liftthe battery connector up out of itssocket on the logic board.
MacBook Pro 13" Unibody Mid 2009 Battery Replacement Draft: 2019-05-20Guide ID: 1332 -
This document was generated on 2019-09-16 01:34:16 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 5
To reassemble your device, follow these instructions in reverse order.
Step 5
Lift the battery out of the upper case.
If you're installing a new battery, youshould calibrate it after installation:
Charge it to 100%, and then keepcharging it for at least 2 morehours. Next, unplug and use itnormally to drain the battery.When you see the low batterywarning, save your work, andkeep your laptop on until it goesto sleep due to low battery. Waitat least 5 hours, then charge yourlaptop uninterrupted to 100%.
If you notice any unusualbehavior or problems afterinstalling your new battery, youmay need to reset yourMacBook's SMC.
MacBook Pro 13" Unibody Mid 2009 Battery Replacement Draft: 2019-05-20Guide ID: 1332 -
This document was generated on 2019-09-16 01:34:16 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 5