Level CrossingProtection Systems

APPlicAtionsFull range of level crossing Protection systems

TEcHnical FEaTurEs oF THE MicroprocEssor basED lEvEl crossinG proTEcTion sysTEM n concept based on the interaction between the

2-of-3 vital processor system and the peripheral groups for train detection, roadside signals and barriers. each control processor runs the same software in fixed cycles. system faults are

detected by comparing the information between the three independent channels n Broad range of power supply system monitoring

featuresn local and remote diagnostics

zelisko hAs More thAn 50 yeArs exPerience in the Field oF rAil signAlling

Around the world, level crossings are often seen as PotentiAlly dangerous sPots for road users. in addition to co-ordinating road and rail traffic, level crossing installations must be reliable and safe but also cost-effective and economical to maintain. zelisko railway signalling technology meets all of these demands.

cusToMEr bEnEFiTsn complete product range: systems with road side signals,

half and full barrier systems, stand-alone systems, main signal covered systems with an interlocking monitoring interface

n complete system suppliern trackside led signals with self-diagnosis reduce

life-cycle costsn support over complete life-cycle

l E v E l c r o s s i n G s y s T E M s

r A i l v e h i c l e s y s t e M s

proDucT ranGEn complete level crossing protection systems

with electronic control technologyn type approved led railway signalsn single components on demand

Complete roadside signals with

different lamp technologies

e.g. incandescent lamps with

single or double filament,

double halogen lamps or LED

RBUeT Oe Diagnostic

RBUeT OeLED-Signal EU for rail applications Remote Maintenance System

Complete barriers with drives for 24 V DC supply voltage

aDDiTional FEaTurEsn easy modification in the event of alterations

and extensionsn rapid implementation of customer requirements

through simple configurationn low life-cycle costs

P-12

18-E

N 09

.2016

This publication may be subject to alteration without prior notice. A printed copy of this document may not be the latest revision. Please contact your local Knorr-Bremse representative or check our website www.knorr-bremse.com for the latest update. The figurative mark “K” and the trademarks KNORR and KNORR-BREMSE are registered in the name of Knorr-Bremse AG. Copyright 2016 © Knorr-Bremse AG. All rights reserved, including industrial property rights applications. Knorr-Bremse AG retains all power of disposal, such as for copying and transferring.

Dr. techn. Josef Zelisko, Fabrik für Elektrotechnik und Maschinenbau Gesellschaft m.b.H.

Beethovengasse 43-452340 MödlingAustriaPhone: +43 2236 409-2229Fax: +43 2236 409-2279

w w w . z e l i s k o . A t w w w . k n o r r - B r e M s e . c o M