lecture_5 electrical engineering iit g
DESCRIPTION
EE101TRANSCRIPT
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
Department of
Electronics & Communication Engineering
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
Lecture 5
The Forced Solution
By
Dr. Praveen Kumar
Assistant Professor
Department of Electronics & Communication Engineering
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
The response to sinusoidal
source In Fig.1, the excitation is
(1)
The equilibrium equation is found from the relationship
(2)
Rearranging the terms of eq.2 gives
(3)
The right hand side of eq.3 is simplified as
(4)
The eq.4 clearly indicates that the assumed form of the forced solution must contain both a sine
and a cosine component in order to have left hand side equal to the right hand side.
1( ) 10sin(3 )e t t
2
1 2
1 2 4( ) ( ) 10sin(3 )
4 11 8f
ad
p pi t e t t
Z p p
2 2(4 11 8) ( ) (2 4 )10sin(3 )fp p i t p p t
2(2 4 )10sin(3 ) 180sin(3 ) 120cos(3 )p P t t t
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
The response to sinusoidal
source 1 1/ 2F 2
1
2H
110sin(3 )t
Figure 1: Network with sinusoidal excitation
a b c
d
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
The response to sinusoidal
source The assumed solution is
(5)
(6)
(7)
Using eq.5 to 7 to substitutes the values of if(t), pif(t) and p2if(t) into eq.4 gives
(8)
Equating the coefficients of sin(3t) and cos(3t) in eq.22 gives
(9)
(10)
The complete forced solution is
(11)
2
( ) sin(3 ) cos(3 )
( )( ) 3 cos(3 ) 3 sin(3 )
( ) 9 sin(3 ) 9 cos(3 )
f
f
f
f
i t A t B t
di tpi t A t B t
dt
p i t A t B t
( 28 33 )sin(3 ) (33 28 )cos(3 ) 180sin(3 ) 120cos(3 )A B t A B t t t
28 33 180
33 28 120
4.8 and 1.38
A B
A B
A B
( ) 4.8sin(3 ) 1.38cos(3 )fi t t t
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
The response to Polynomial
Sources The excitation function in the Fig.2 is
(12)
The function in eq.12 varies linearly with time and has a slope of 2. Because of its sloping
graphical representation, eq.12 is also referred to as ramp function.
The current if(t) is given by
(13)
Rearranging the eq.13 gives
(14)
Simplifying eq.14 gives
(15)
( ) 2f t t
2
2
1 2 4 2( ) ( ) (2 )
4 11 8f
p pi t e t t
Z p p
2 2(4 11 8) ( ) (2 4 2)(2 )fp p i t p p t
2(4 11 8) ( ) 8 4fp p i t t
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
The response to Polynomial
Sources
Fig.2: Network with sinusoidal excitation
1 1/ 2F 2
11
2H2t
a b c
d
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
The response to Polynomial
Sources The forced response can be written as the sum of a constant term plus a ramp. Hence
(16)
Substituting if(t) from eq.16 into eq.15 gives
(17)
Equating the like coefficients and solving for the unknown quantities gives
(18)
The complete expression for the forced solution becomes
(19)
( )fi t A Bt
11 8 8 8 4B A Bt t
5 1,
16 2A B
5 1( )
16 2fi t t
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
The Natural Response (Transient
Solution) The forced solution is the solution that is found to exist when the circuit has settled down in its
response to the disturbing effect of an applied source function. This forced solution is also known
as steady state solution.
The forced or the steady state solution always satisfies the defining differential equation but in
general it is not a valid a solution over the entire time domain.
To illustrate the point consider the circuit shown in Fig.3. In this network it is desired to find the
complete solution for the voltage v appearing across the resistor for all time t after the switch is
closed.
The equation that relates v to the source voltage E is
(20)
(21)
1
1 ( )
v R
LE R pLp
R
L dvv E
R dt
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
The Natural Response (Transient
Solution)
Fig.3: An R-L circuit
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
The Natural Response (Transient
Solution) The forced solution of eq.21 is
(22)
The solution in eq.22 satisfies eq.21, however this solution does not qualify as a solution of the
governing differential equation in the period immediately following the closing of the switch at
time
At time the current is zero because of the presence of the inductor. Hence v, which is iR, is
also zero. Hence, the solution in eq.22 cannot be taken to be a complete description.
In essence, then, there arises, in this time period, , immediately following the application of
the source function, a need to add a complementary function to the forced solution.
This complementary function will disappear as steady state is reached. It is the purpose of the
complementary function to provide a smooth transition from the initial state of the response in
the presence of energy storing elements to the final state.
fv E
0t
0t
0t
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
The Natural Response (Transient
Solution) In Fig.3, the complementary function (natural response) is obtained by solving the equation
(23)
The solution to the eq.23 should satisfy that function, v and its derivative, dv/dt, must be of the
same form to make the left hand side equal to the right hand side.
The plausible solution for eq.23 is
(24)
Substituting v from eq.24 into eq.23 gives
(25)
(26)
0L dv
vR dt
stv Ke
1 0stLs Ke
R
Rs
L
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
The Natural Response (Transient
Solution) Hence, the complementary solution becomes
(27)
The complete solution of the original governing differential equation (eq.23) is
(28)
The quantity K is found from the initial condition which requires that v to be zero at t=0+
(29)
Hence, the complete solution is
(30)
A graph of eq.30 is shown in Fig.4. The rapidity with which this transition takes place is entirely
dependent upon the value s. In eq.26 when R is large (or L is small) the transition occurs quickly
because the transient term dies out in little time.
( / )R L tv Ke
0 E K K E
( / )(1 )R L tv E e
( / )R L tv E Ke
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
The Natural Response (Transient
Solution) vf=E
V=vf+vt
vt=-Ee-(R/L)t
Fig.4: Complete solution of voltage across the resistor in network 3
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
Example 1
Consider the network shown in Fig.5. The differential equation governing the voltage V to the
source E, is
(31)
The associated differential equation is
(323)
The forced solution is
(33)
The characteristics equation is
(34)
2 2
1
1 4
1 1 5 4
pCv E E
p LC pRC p pR pL
pC
2
25 4 4
d v dvv E
dt dt
2( ) ( ) 5 4 ( 4)( 1) 0D p D s s s s s
2
0
4
5 4f f
p
v E E v Ep p
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
Example 1
Fig.5: Network for the example
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
Example 1
Hence
(35)
Since there are two unknown coefficients, two initial conditions are required. The first is that v
has a zero value at time t=0+, then
(36)
To determine the second initial condition, differentiate the eq. 35
(37)
1 2
4
1 2
4
1 2
4, 1
Hence, the complementary solution is
Hence, the complete solution is
t t
t
t t
f t
s s
v K e K e
v v v E K e K e
1 2(0 ) 0v E K K
4
1 24 t tdvK e K e
dt
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
Example 1
The term dv/dt is the voltage drop across the capacitor. At time t=0+, the voltage across the
capacitor is zero because the inductor does not allow the current to flow the network
immediately. Hence,
(38)
Solving eq.49 and eq.51 gives
(39)
The complete solution is
(40)
4
1 2
1 2
4 0
4 0
t tdvK e K e
dt
K K
1 2
4,
3 3
EK K E
41 4(1 )
3 3
t tv E e e
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
-150
-100
-50
0
50
100
150
0 2 4 6 8 10 12
Example 1
41 41
3 3
t tE e e
Time
Volt
age
Fig.6: Response of network shown in fig.5
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
Example 2
Consider the circuit shown in Fig. 7. The configuration of this circuit is same as in Fig.5 except
for the fact that the resistance is reduced to 2 Ohms.
The voltage v is given by
(41)
The forced component of the solution is obtained by
(42)
The characteristic equation and its roots are
(43)
2
4
2 4v E
p p
2
0
4
2 4f f
p
v E E v Ep p
2
1
2
( ) ( ) 2 4
1 3
1 3
D p D s s s
s j
s j
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
Example 2
It is important to note that the roots are no longer real and distinct but are complex conjugates.
This should lead us to expect some essential difference in the behaviour of the circuit as it reacts
to the application of the source function.
This difference is seen by writing the expression for the transient response:
(44)
Applying Euler’s formula , eq.44 can be written as
(45)
It should be kept in mind that the left hand side of eq.45 is a real quantity. Moreover, vf is
associated with a differential equation that has real coefficients.
1 2 3 3
1 2 1 21/s t s t i t j t
fv K e K e e K e K e
cos sinie j
1 2 1 21/ cos 3 sin 3fv e K K t j K K t
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
Example 2
Hence, the right hand side of eq.45 must also necessarily have real coefficients.
This implies that the term j(K1-K2) merely means that K1-K2 must assume such a value as to
lead to a real coefficient.
For ease of handling, the eq.44 can be rewritten as
(46)
The complete expression of the total solution is
(47)
Upon applying initial conditions to eq.47, the values of k1 and k2 can be obtained.
1 21/ cos 3 sin 3fv E v E e k t k t
1 21/ cos 3 sin 3fv e k t k t
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
Example 2
The first initial condition is
(48)
To find k2, it is necessary to impose a second initial condition.
(49)
Using eq.48, k2 is found as
(50)
Substituting k1 and k2 into eq.47 gives
(51)
The response of the system is shown in Fig.7
1 11 cos 3 sin 3
3v E t t
e
1 1(0 ) 0v E k k E
2 10 3dv
k kdt
12
3 3
k Ek
Electronics & Communication Engineering
Indian Institute of Technology Guwahati
Example 2
-20
0
20
40
60
80
100
120
140
0 2 4 6 8 10 12
Time
Volt
age
Fig.7: Response of network