kx-ns1000 basic specification august 22, 2014 this document explains basic specification of...

KX-NS1000Basic Specification

August 22, 2014

This document explains basic specification of KX-NS1000 version 4.1.It is recommended to know basic specification of KX-NS small PBX before reading this document.Specifications are subject to change without notice.

Panasonic System NetworksPBX SE team

Document for Technical and Sales Training

2

KX-NS1000 is bigger capacity model of KX-NS PBX series.KX-NS1000 supports 1,000 extensions. 1,000 IP phone or 1,000 Digital PT or 1,000 SLT or 1,000 mixture

KX-NS1000 supports lots of built-in solution. Voice Mail, Unified Message, Recording, Call center, Unified Communication, Mobility, Conference, One-look networking and so on

1. Introduction

IP Network

KX-NS1000Master

100 % Feature transparency like TDE600 and TDE620

KX-NS1000Slave

Built-inSolution

KX-NS8188 E1 adapterKX-NS8290 PRI adapter

1,000Extension

KX-NS0130

KX-DT w/ SLT KX-DT KX-T7xxx SLT DSS Console

KX-NT KX-UT Other SIP SIP Phone Softphone

KX-NS0130

KX-TDE620 etc

Max. 16KX-NS1000

3

KX-NS small PBX and KX-NS1000 have same feature basically like KX-NCP and KX-TDE. Feature difference is as follows.

2. Feature Difference

(*) These features are not available when KX-NS small PBX is connected with KX-NS1000 by one-look network.

Feature KX-NS small PBX KX-NS1000

One-look network Yes (as slave) Yes

Trunk Adapter : KX-NS8188/8290 See “1. NSx00 Basic Spec 2014-xxxx.pptx.” Yes

RS232 port No but SMDR through LAN Yes

LAN port 10/100 Base TX 10/100/1000

WAN port No Yes

MNT port No but USB port with adapter Yes

Fax to e-mail No Yes

Sensor to e-mail Yes Yes (Version 4.1)

Simple VM Yes (*) No

Modem : KX-TDA0196 Yes (*) No

PT Program Yes (*) No

40,000 calls SMDR by SD Yes (*) No

4

3. Table of Contents

Chapter Contents

1 Basic configuration

2 Stacking card / One-look networking

3 Trunk adapter (E1/PRI)

4 WAN (Built-in Router)

5 Activation key

6 Capacity (Review & Conditions)

5

Chapter 1Basic Configuration

6

Front View

A C D E F

J

B

G H I

M Power Switch

N Earth Terminal

O AC Inlet

P Clip Hole for AC cable

Q MPR ID

R RS-232C Port

Back View

M N R

O

P Q

A

3 Indicator for(1) System(2) Battery(3) Master / Slave

B Default Switch

C USB Port

DLAN portfor maintenance PC (*)

ELAN Portfor customer network

F WAN Port

G MOH Port

H Pager Port

I Doorphone Slot

J Free Slot

(*) D is independent from E. D is useful when PC for maintenance is not allowed to connect to customer’s network. D and E for TDE/NCP were for same network.

13. KX-NS1000 Main Unit

7

Two DSP can be installed.

14. Optional Cards on Mother Board

Hot swap is not available.

8Hot swap is not available.

2 analogue trunk ports with Caller ID (FSK/FSK with Call Waiting Caller ID /DTMF).One port is a power failure transfer (PFT) port.2 extension ports with Caller ID (FSK) for SLTs.

15. Optional Cards on Front

9

Chapter 2Stacking Card

One-look Network

10

21. Stacking Card

IP Network

KX-NS1000


640Extension

KX-DT w/ SLT DSS Console


KX-NS0130

KX-TDE620 etc

When customer needs lots of analog SLT, digital PT, analog CO, PRI and so on, KX-NS1000 with stacking card KX-NS0130 is useful.- KX-TDA100-200-600-620, KX-TDE or KX-NCP works as slave unit.- 2 slave units are supported with one KX-NS1000 by one KX-NS0130. - KX-NS0131/0132 is installed to slave unit instead of MPR or BUS card. - KX-TDA(E)620 cannot be connected with KX-TDA(E)600 by BUS card.

Built-inSolution

KX-NS0130 Stacking card for NS1000

KX-NS0131 Stacking card for NCP

KX-NS0132 Stacking card for TDA/TDEDSP

11

22. One-look Networking

IP Network

KX-NS1000Master


KX-NS1000Slave

Built-inSolution

1,000Extension

KX-NS0130

KX-DT w/ SLT KX-DT KX-T7xxx SLT DSS Console


KX-NS0130

KX-TDE620 etc

Max. 16KX-NS1000

A maximum of 12 KX-TDA/TDE/NCP and 16 KX-NS1000 can be connected for the entire One-look Network for 1,000 extensions.One-look networking is similar to TDE600-TDE620 connection. KX-NS1000 master works like KX-TDE600. Other units work like KX-TDE620. All programming is available through KX-NS1000 master like KX-TDE600.

Activation key : KX-NSN001 is required for each KX-NS PBX.

Max. 12KX-TDA/TDE/NCP

DSPDSP

Maximum of KX-TDA/TDE/NCP was 8 for KX-NS1000 version 4.0 or before.

12

23. One-look Networking with KX-NS small PBX

A maximum of 15 KX-NS small PBX also can be connected for the entire One-look Network as slave PBX. Master PBX should be KX-NS1000. Activation key : KX-NSN001 is required for each PBX. Hardware : DSP such as KX-NS5110 is required because VoIP is used for connection.

(A) Max. 12KX-TDA/TDE/NCP

DSP

DSPKX-NS0130

DSP(C) KX-NS1000 master +15 KX-NS1000 or KX-NS small PBX

IP Network

(B) Max. 24KX-NS320KX-NS520KX-NS720

(A)+(B)Total

TDA/TDE/NCP 0 1 2 3 4 5 6 7 8 9 10 11 12

NSx20 24 22 20 18 16 14 12 10 8 6 4 2 0

KX-NS300 : KX-NSF990 AK and SD card such as KX-NS3134 are also required.KX-NS700 : KX-NSF991 AK is also required.

KX-NS small PBX cannot be master (including back-up master) because not enough CPU.

KX-NS small PBX

KX-NS1000

Max. 1,000Extension

13

When customer is using KX-TDA/TDE/NCP with Q-SIG, KX-NS1000 with one-look networking is useful for more features such as paging.

IP Network

KX-TDE600

KX-TDE620

KX-NCP

IP Network

KX-DT KX-DT KX-DT

KX-TDE600 KX-TDE620

KX-NCP

Stacking

Stacking

Stacking

StackingStacking

QSIG

Max. 8 PBXs

24. Upgrade from QSIG

100 % Feature transparency

Paging

PagingPaging

KX-DT KX-DT KX-DT

14

Chapter 4WAN (Built-in Router)

15

41. WAN (Built-in Router)

One internet line can be usedfor both PC and VoIP.

When customer wants to add one more internet for VoIP (Extension or Trunk),Add one more router.

WAN (Built-in Router) is supported from KX-NS1000 version 3.Hardware for WAN is available since version 1 mass production. Activation key : KX-NSN101 is required.

LAN (Customer’s network)192.168.0.101 (Default)

IP Network

LANLAN for Maintenance223.0.0.1 (Default)

IP Network

WAN Router

LAN

IP Network

WAN

LAN

WAN

WANRouter

PortFwd

PortFwd

Or use built-in router.Port Fwd is not required.

Router

16

42. Built-in VPN

WAN / Built-in Router can support VPN (IP-SEC) feature also.VPN is required if one-kook network is configured using built-in router. Activation key : KX-NSN216 is required. (KX-NSN101 is also required.) One KX-NSN216 supports 16 VPN connection. Max. two AKs can be supported for 32 VPN connection.

IP phone also can be connected using VPN for secured communication instead of MRG feature.

Easy Installation even for VPNby Panasonic technology “VPSS”.

Router

VPNVPN

IP Network

Router

VPN

Router

External VPN

Router

17

Chapter 5Activation Key

18

51. Activation key only for KX-NS1000

Following activation key is only for KX-NS1000.

19

Pre-installed

Model Name Feature Maximum Description

KX-NSX910Expansion AKfrom NSM005

1 AK IP phone Capacity is increased to 100ports





These AK are required for each master and slave PBX.

NSM005NSM010

NSM030NSM099

30 50 100 300 640

NSX910 NSX930 NSX999

IP phone

NSX930 NSX999NSX999

60days free trial is NOT available.

52. Activation Key for Expansion

Following activation key was added from KX-NS1000 version 3.

20

Following features are available without buying activation key and without expiration.

IP Extension for KX-UT and KX-NT hardware phone : 8ch

- Not for KX-NT700 and KX-NT based software phone - Not for 3rd party SIP phone => Easy to sell Panasonic KX-UT and KX-NT

UM (Built-in KX-TVM) : 2 ch

CA Basic (Built-in server / External server) : All users

53. Pre-installed Activation Key

21

Chapter 6Capacity

(Review and Conditions)

22

Capacity is as follows.Line NS1000

x 1NS1000

x 2NS1000x 3 to 16

Trunk 256 256 x 2 600

Legacy 256 256 x 2 600

IP incl E1/PRI adapter 256 256

SIP incl PRI Public mode 256 256

H.323 incl PRI QSIG mode 48 96

Extension 640 1000

Digital PT / Analog PT / SLT 480 SLT (*1)512 DPT (*2)

1000

IP 640 1000

(*1) 24SLT x 10 by TDE620 x 2 for example (*2) 256 DPT including DXDP by TDE620 x 2 for example

Capacity is occupied when hardware card and virtual IP card are installed, even if phone is not connected actually.For example, one DLC16 occupies 32-ch including Digital XDP.

61. Capacity - Summary

23

Type 2 Stand Alone One-look

IP 640 1000

　 IP-PT (KX-NT series) 640 1000

SIP 256 1000

　 SIP Phone 256 1000

KX-UT series 256 1000

Type 1 (Default) Stand Alone One-look

IP 640 1000

　 IP-PT (KX-NT series) 256 1000

SIP 640 1000

　 SIP Phone 640 1000

KX-UT series 640 1000

KX-NT capacity for one unit of KX-NS1000 can be increased.Type 1 or Type 2 can be selected after default clear.

Type 3 is also available to increase H.323 ch. : 128 ch for NS1000 2 or more unitBut capacity of IP extension reduces. See Installation manual for details.

63. Capacity - KX-NT

24

Total 1000 extensions

Slave PBX

One VM channel reduces 10-port extension capacity of master PBXbecause CPU of master PBX needs more power for VM.- Default 2-ch does not reduce this.- Extension capacity of slave PBX does not reduce, even if slave PBX has VM because CPU of slave PBX is not so busy.

VM (ch) Extension

Default 2 640

2 + 2 620

2 + 4 600

:

2 + 22 420

VM (ch) Extension

Default 2 640

2 + 2 640

2 + 4 640

:

2 + 22 640

Master PBX VM VM

64. Capacity - Conditions

25

66. DSP Configuration Tool

Capacity of DSP can be confirmed using programming tool without PBX before installtion. (Off-line mode)

26

DSP can be booked for more important purpose by programming.

<Above example>3ch OGM(DISA) can be used always. 4 or more ch OGM(DISA) can be used from “Free resources”.

67. DSP Booking

27

DSP report is supported.

68. DSP Report

28

Thank you !

29

Revision

Date No. Change

Aug 22 All First release

kx-ns1000 basic specification august 22, 2014 this document explains basic specification of...

Documents