kta-289 ktc-289 - electronics123 · kta-289 voltage to 4-20 ma converter • adjustable input range...
TRANSCRIPT
KTA-289 Voltage to 4-20 mA Converter
• Adjustable Input Range• From 0-0.1V up to 0-2.3V
Input in Amplify Mode• From 0-4.9V up to 0-30V
Input in Divide Mode• 4 to 20mA Output• Screw Terminal
Connections• DIN Rail Mount
Enclosure
KTA-289 KTC-289
+The KTA-289 can take a voltage signal, from below 0.1V to above 30V and convert it to a 4-20mA signal. The full scale of the input signal needs to be below 2.3V or above 4.9V.To convert voltage signals with full scale voltage between 2.3V and 4.9V it is recommended to use 5V as the full scale range, or contact Ocean Controls with your requirements.
Connections
Connection Function
V+ Positive Power Input (8-30VDC)
GND Common Ground Return of Power Input
INPUT Input Voltage Signal Positive
GND Common Ground Return of Input Signal
OUTPUT Output 4-20mA Signal Positive
GND Common Ground Return of Output Signal
Configuration
The KTA-289 must be configured to work for the voltage range of your application. To do this a voltage source ofthe full scale voltage is required.Follow these steps to configure the unit for any voltage range.When using with signals with full range greater than 3.3V move the switch to the Divide position.When using with signals with full range lower than 3.3V move the switch to the Amplify position.Short out INPUT to GND and adjust the 4mA adjustment potentiometer until 4mA is seen on the OUTPUT.Input a maximum range signal to the INPUT pin and adjust the 20mA adjustment potentiometer until 20mA is seenon the OUTPUT pin, the KTA-289 is now ready for use.
Ordering Information
KTA-289
29 Jan 2014 www.oceancontrols.com.au 1 of 1
A: Converter card in DIN Rail Mount EnclosureC: Converter card without enclosure or screw terminals