killark fwer2r23lame arrestor
DESCRIPTION
sdfwerw3wewewr23r3werw3TRANSCRIPT
-
KDB/KB SERIES FITTINGSDRAINS/BREATHERS/FLAME ARRESTORS
F64
IEC Ex CSA 10.0007u
Cer t i f i ed - Fi le LR11716
KDB-1 KB1B KB1D
Lis ted - Fi le E10514
IEC Ex CSA 10.0007u
Cer t i f i ed - Fi le LR11716
Cer t i f i ed Fi le 25215FMAPPROVED
Class I, Div. 1 & 2, Groups B1,C,DClass I, Zones 1 & 2, Groups IIB + H21Class II, Div. 1 & 2, Groups E,F,GClass III, NEMA Type 3II 2 G Ex d IIB IIC2 T226C Gb IP44
1 See chart below forsuitability
2Warning - not for usein acetylene atmosphere
NEW OPTIONSNEW LISTINGS
ATEX PENDING4/2011
TYPICAL INSTALATION
1See chart below for suitability2Warning - not for use in acetylene
atmospheres
2
2
ATEX PENDING 4/2011
Class I, Div. 1 & 2, Groups B1,C,DClass I, Zones 1 & 2, Groups IIB + H21Class II, Div. 1 & 2, Groups E,F,GClass III, NEMA Type 3, 41II 2 G Ex d IIB IIC2 T3 Gb IP661
7/8
2.96
KB SERIES FLAME ARRESTOR
KB/KD SERIES DRAIN &BREATHERSApplicationsWhen installed in the top of an enclo-sure, these fittings act as breatherswhich allows air flow through the
ApplicationsThe flame arrestor provides a meansto connect gas analysis equipmentand electro pneumatic devices' pipeor tubing system through the wall ofan explosion-proof enclosure.BODY MATERIAL: 6061--T6 seriesaluminum provided as standard.Optional stainless steel or brass forspecial orders.
enclosure. Bottom installations permitwater from condensation to drain fromthe enclosure continuously. Thedrains and breathers are offered in avariety of hub sizes, 1/4, 3/8 & 1/2inch NPT and metric M16 & M20.
Body MaterialAluminum with optional stainless steelor brass available for special orders.VolumeFor use in enclosures with a maximuminternal volume to 9526 cubic inchesor 160 liters.
SpecificationsAir flow = 83 + 15 / -25 SCFH at 5PSIPressure drop = 1.3 PSI at 100 PSIMaximum flow pressure = 800 PSIVolume = For use in enclosures witha maximum internal volume of 9526cubic inches or 160 liters.
NEW!