jawbone icon manual

2
TALKING POINTS 1 GET CONNECTED IN 30 SECONDS SLIDE ON LED PRESS + HOLD TALK BUTTON 1.1 PREPARE YOUR JAWBONE Press and hold the TALK BUTTON while sliding ON your Jawbone until the LED flashes RED + WHITE . This indicates that the Jawbone is ready to connect (pairing mode). 1.2 PREPARE YOUR PHONE Turn on the Bluetooth® settings. ON AN IPHONE® Go to SETTINGS > GENERAL > and enable BLUETOOTH® ON A BLACKBERRY® Go to SETTINGS/OPTIONS > BLUETOOTH > and enable BLUETOOTH® OTHER CELL PHONES Go to JAWBONE.COM/PAIRING or review the instruction manual that came with your phone 1.3 MAKE THE CONNECTION Go to your phone’s Bluetooth® settings. ADD OR SEARCH FOR DEVICES When “Jawbone ICON” appears, select it IF ASKED FOR A PASSCODE, enter “ 0000 This is a one-time event you should not have to repeat, unless you are connecting your Jawbone headset to a new phone. 2 GET COMFORTABLE 2.1 FIND YOUR FIT Mix and match to select the most comfortable and secure fit option. Jawbone can be worn WITH or WITHOUT an earloop. 2.2 DROP, TWIST & POINT For the most secure fit, place your Jawbone in your ear pointing down. Then twist it upwards so it points directly at your mouth.

Upload: bsdstores

Post on 15-Oct-2014

1.463 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: JAWBONE ICON MANUAL

TALKING POINTS

1GET

CONNECTEDIN 30 SECONDS

SLIDE ON

LED

PRESS + HOLDTALK BUTTON

1 . 1 PREPARE YOUR JAWBONE

Press and hold the TALK BUTTON while sliding ON your Jawbone until the LED flashes RED + WHITE . This indicates that the Jawbone is ready to connect (pairing mode).

1 . 2 PREPARE YOUR PHONE

Turn on the Bluetooth® settings.

ON AN IPHONE ®

Go to SETTINGS > GENERAL >

and enable BLUETOOTH ®

ON A BLACKBERRY®

Go to SETTINGS/OPTIONS >

BLUETOOTH > and enableBLUETOOTH ®

OTHER CELL PHONES

Go to JAWBONE .COM / PAIRING

or review the instruction manualthat came with your phone

1 . 3 MAKE THE CONNECTION

Go to your phone’s Bluetooth® settings.

ADD OR SEARCH FOR DEVICES

When “Jawbone ICON” appears, select it

IF ASKED FOR A PASSCODE,

enter “0000”

This is a one-time event you should not have to repeat, unless you are connecting your Jawbone headsetto a new phone.

2GET

COMFORTABLE

2 . 1 F IND YOUR FIT

Mix and match to select the most comfortable and secure fit option.

Jawbone can be worn WITH orWITHOUT an earloop.

2 . 2 DROP, TWIST & POINT

For the most secure fit, place your Jawbone in your ear pointing down. Then twist it upwards so it points directly at your mouth.

Page 2: JAWBONE ICON MANUAL

2 . 3 ENSURE BEST QUALIT Y

Jawbone works regardless of position, but you will get the best performance if the Voice Activity Sensor physically touches your cheek.

VOICEACTIVIT YSENSOR

3TALK

T A L K B U T T O N

3 . 1 TAKE A CALL

Press the TALK BUTTON on your Jawbone to answer. When you are finished talking, press the TALK

BUTTON to hang up.

3 . 2 MAKE A CALL

Use your phone to dial as usual. Listen and talk through your Jawbone. To hang up, just press the TALK BUTTON .

4POWER UP,

ETC.L E D

4 . 1 GET JUICED

Your Jawbone is partially charged and ready for use right out of the box.

WHEN BATTERY LOW

The LED indicator flashes RED .

FOR A FULL CHARGE

Plug it in.

NOTE It takes 40 minutes to get your Jawbone 80% charged. A full charge takes 90 minutes.

WHEN FULLY CHARGED

The LED indicator turns WHITE .

G ET MORE H E LP ( IF YOU NEED IT )

VISIT JAWBONE .COM / SUPPORT

CALL 1 - 877 - ALIPHCO ( 254 - 7426)

GO TO JAWBONE .COM / WARRANT Y

for warranty info

PURCHASE the official JawboneCar Charger and other accessoriesat JAWBONE .COM

Become a fan of Jawboneon Facebook®VISIT JAWBONE .COM / FACEBOOK

© 2 0 1 0 A L I P H C O M . A L L R I G H T S R E S E R V E D . 7 7 0 - 0 0 1 5 0 R E V H